Fabrication and Testing of Metal Foil Planar Switch
نویسندگان
چکیده
منابع مشابه
Fabrication and testing of planar chalcogenide waveguide integrated microfluidic sensor.
We have fabricated and tested, to the best of our knowledge, the first microfluidic device monolithically integrated with planar chalcogenide glass waveguides on a silicon substrate. High-quality Ge(23)Sb(7)S(70) glass films have been deposited onto oxide coated silicon wafers using thermal evaporation, and high-index-contrast channel waveguides have been defined using SF(6) plasma etching. Mic...
متن کاملDesign and fabrication of a prototype planar undulator
The main goal of this work is to get the fabrication technology of the insertion devices. A prototype undulator with the period of 48mm and the peak magnetic field of 0.75 T has been fabricated using NdFeB-SH35 magnets based on the cooperation between ILSF and NSTRI. The total magnet length is 483 mm and the number of periods is 8. The magnetic parameters of the undulator are determined in orde...
متن کاملFabrication, Assembly, and Testing of Metal-based Microchannel Heat Exchangers
Microsystem technologies are believed to be an important part of the technological foundation upon which the world can continue to improve the standard of living in the twenty-first century. Microelectromechanical systems (MEMS) have been studied intensely for over two decades. Si-based MEMS, fabricated by surface and bulk micromachining techniques derived from IC processing technology, dominat...
متن کاملFabrication of Buried Co-Planar Metal-Insulator-Metal Nanojunctions with a Gap Lower than 10 nm
An improvement of a process to fabricate co-planar metal-insulator-metal nanojunctions is presented to reach a gap length much lower than lo nm using a 20 kev e-beam and an AuPd lift-off. The electrodes of the nanojunction are less than loo nm in width and are buried in the Si02 substrate. For the 8 nm nanojunctions, the gap is still filled with Si02 if care is taken about the Si02
متن کاملAccelerated Testing of Metal Foil Tape Joints and Their Effect on Photovoltaic Module Reliability
A program is underway at Sandia National Laboratories to predict long-term reliability of photovoltaic (PV) systems. The vehicle for the reliability predictions is a system performance model, currently being run under a simulation software called GoldSimTM. The model includes inputs for module performance, irradiance, and degradation. In order to be truly predictive, physics-informed degradatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Defence Technology
سال: 2013
ISSN: 2214-9147
DOI: 10.1016/j.dt.2012.11.001