Fabrication of 3D Bi2O3-BiOI heterojunction by a simple dipping method: Highly enhanced visible-light photoelectrocatalytic activity
نویسندگان
چکیده
منابع مشابه
Facile synthesis of a ZnO–BiOI p–n nano-heterojunction with excellent visible-light photocatalytic activity
In this paper, an efficient method to produce a ZnO/BiOI nano-heterojunction is developed by a facile solution method followed by calcination. By tuning the ratio of Zn/Bi, the morphology varies from nanoplates, flowers to nanoparticles. The heterojunction formed between ZnO and BiOI decreases the recombination rate of photogenerated carriers and enhances the photocatalytic activity of ZnO/BiOI...
متن کاملHeterojunctions of p-BiOI Nanosheets/n-TiO₂ Nanofibers: Preparation and Enhanced Visible-Light Photocatalytic Activity.
p-BiOI nanosheets/n-TiO₂ nanofibers (p-BiOI/n-TiO₂ NFs) have been facilely prepared via the electrospinning technique combining successive ionic layer adsorption and reaction (SILAR). Dense BiOI nanosheets with good crystalline and width about 500 nm were uniformly assembled on TiO₂ nanofibers at room temperature. The amount of the heterojunctions and the specific surface area were well control...
متن کاملNew photocatalyst BiOCl/BiOI composites with highly enhanced visible light photocatalytic performances.
BiOCl/BiOI composites with a visible light response were prepared by a simple hydrothermal method. Even though both single BiOCl and BiOI show low photocatalytic activity, BiOCl/BiOI composites provide enhanced efficiency in decomposing organic compounds including Methyl Orange (MO) and Rhodamine B (RhB). Furthermore, the 20%BiOCl/BiOI composite shows the highest efficiency for decomposing MO, ...
متن کاملSimple fabrication of N-doped mesoporous TiO2 nanorods with the enhanced visible light photocatalytic activity
N-doped mesoporous TiO2 nanorods were fabricated by a modified and facile sol-gel approach without any templates. Ammonium nitrate was used as a raw source of N dopants, which could produce a lot of gasses such as N2, NO2, and H2O in the process of heating samples. These gasses were proved to be vitally important to form the special mesoporous structure. The samples were characterized by the po...
متن کاملFabrication of CaFe2O4/MgFe2O4 bulk heterojunction for enhanced visible light photocatalysis.
A bulk heterojunction photocatalyst of interfacing CaFe(2)O(4) and MgFe(2)O(4) nanoparticles is highly active for oxidative degradation of isopropyl alcohol and hydrogen production from water under visible light, because the exciton easily reaches the interface and dissociates to minimize recombination.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical Engineering Journal
سال: 2017
ISSN: 1385-8947
DOI: 10.1016/j.cej.2016.08.114