Flow regime based heat transfer correlation for R245fa in a 3 mm tube
نویسندگان
چکیده
منابع مشابه
Heat Transfer Correlation for Two Phase Flow in a Mixing Tank
Mixing tanks equipped with mechanical stirrer are broadly applied in chemical and petrochemical industries, due to their variety of industrial process requirements. In this study, helical single blade mixer was designed applying CATIA and then mixing of fluid and solid particles, in a tank with this agitator was examined by OpenFOAM. For velocity distribution in the mixing tank, continuity, mom...
متن کاملConvective Heat Transfer of Oil Based Nanofluid Flow Inside a Circular Tube
Abstract An empirical investigation was carried out to study convective heat transfer of nanofluid flow inside an inclined copper tube under uniform heat flux condition. Required data are acquired for laminar and hydrodynamically fully developed flow inside round tube. The stable CuO-base oil nanofluid with different nanoparticle weight fractions of 0.5%, 1% and 2% was produced by means of ul...
متن کاملHeat Transfer from a Tube Bank in Cross Flow in a Duct
An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies 
in the range 0.055<D/W<0.22. The experimen...
متن کاملHeat Transfer from a Tube Bank in Cross Flow in a Duct
An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies in the range 0.055<D/W<0.22. The experimenta...
متن کاملHeat Transfer in the Transitional Flow Regime
Transitional flow, whereby the motion of a fluid changes from laminar to turbulent flow, was successfully identified by Reynolds (1883) almost 130 years ago. According to ASHRAE (2009), for a round pipe, in general, laminar flow exists when the Reynolds number is less than 2 300. Fully turbulent flow exists when the Reynolds number is larger than 10 000 and transitional flow exists for Reynolds...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Heat and Mass Transfer
سال: 2018
ISSN: 0017-9310
DOI: 10.1016/j.ijheatmasstransfer.2017.10.062