Frictional Properties of a Frictional Material Composited with Fibres of K2O(TiO2)6.
نویسندگان
چکیده
منابع مشابه
System identification of a beam with frictional contact
The nonlinear system becomes an area with numerous investigations over the past decades. The conventional modal analysis could not be applied on nonlinear continuous system which makes it impossible to construct the reduced order models and obtain system response based on limited number of measurement points. Nonlinear normal modes provide a useful tool for extending modal analysis to nonlinea...
متن کاملEffects of frictional material properties on thermoelastic instability deformation modes
This paper deals with the effects of friction material properties on thermoelastic instability (TEI) and the associated dominant deformation mode. Both analytical and finite element models are constructed for determining the variation of the critical speed and the dominant TEI mode. Some important factors, e.g. the nonconductive friction material as well as the symmetric and anti-symmetric TEI ...
متن کاملFrictional properties of confined polymers.
We present molecular dynamics friction calculations for confined hydrocarbon solids with molecular lengths from 20 to 1400 carbon atoms. Two cases are considered: a) polymer sliding against a hard substrate, and b) polymer sliding on polymer. In the first setup the shear stresses are relatively independent of molecular length. For polymer sliding on polymer the friction is significantly larger,...
متن کاملFrictional mechanics of wet granular material.
The mechanical response of a wet granular layer to imposed shear is studied experimentally at low applied normal stress. The granular material is immersed in water and the shear is applied by sliding a plate resting on the upper surface of the layer. We monitor simultaneously the horizontal and the vertical displacements of the plate to submicron accuracy with millisecond time resolution. The r...
متن کاملFrictional properties of a polycationic brush.
The frictional behaviour of end-grafted poly[2-(dimethyl amino)ethyl methacrylate] films (brushes) has been shown by friction force microscopy to be a strong function of pH in aqueous solution. Data were acquired using bare silicon nitride and gold-coated tips, and gold coated probes that were functionalized by the deposition of self-assembled monolayers. At the extremes of pH (pH = 1, 2, and 1...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1991
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.57.2740