Generation and characterisation of few-pulse attosecond pulse trains at 100 kHz repetition rate
نویسندگان
چکیده
منابع مشابه
Fiber amplification of pulse bursts up to 20 μJ pulse energy at 1 kHz repetition rate.
We demonstrate burst-mode operation of a polarization-maintaining Yb-doped fiber amplifier. Groups of pulses with a temporal spacing of 10 ns and 1 kHz overall repetition rate are amplified to an average pulse energy of ∼20 μJ and total burst energy of 0.25 mJ. The pulses are externally compressed to ∼400 fs. The amplifier is synchronously pulsed-pumped to minimize amplified spontaneous emissio...
متن کاملSpectral signature of short attosecond pulse trains.
We report experimental measurements of high-order harmonic spectra generated in Ar using a carrier-envelope-offset (CEO) stabilized 12 fs, 800 nm laser field and a fraction (less than 10%) of its second harmonic. Additional spectral peaks are observed between the harmonic peaks, which are due to interferences between multiple pulses in the train. The position of these peaks varies with the CEO ...
متن کاملPhotonic streaking of attosecond pulse trains
High harmonic radiation, produced when intense laser pulses interact with matter, is composed of a train of attosecond pulses. Individual pulses in this train carry information on ultrafast dynamics that vary from one half-optical-cycle to the next. Here, we demonstrate an all-optical photonic streaking measurement that provides direct experimental access to each attosecond pulse by mapping emi...
متن کاملParametric amplification of attosecond pulse trains at 11 nm
We report the first experimental demonstration of the parametric amplification of attosecond pulse trains at around 11 nm. The helium amplifier is driven by intense laser pulses and seeded by high-order harmonics pulses generated in a neon gas jet. Our measurements suggest that amplification takes place only if the seed pulse-trains are perfectly synchronized in time with the driving laser fiel...
متن کاملFemtosecond damage threshold at kHz and MHz pulse repetition rates
Femtosecond laser-induced damage threshold (LIDT) measurements for different optical components are well studied for a set of laser pulse repetition rates spanning the range between 1 Hz and 1 kHz. Recent years saw the advent of high-repetition-rate femtosecond systems with relatively high pulse energy. Therefore investigation of LIDT in the MHz region is essential. We performed several compara...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics B: Atomic, Molecular and Optical Physics
سال: 2020
ISSN: 0953-4075,1361-6455
DOI: 10.1088/1361-6455/aba77d