Heat-and-pull rig for fiber taper fabrication
نویسندگان
چکیده
منابع مشابه
Fabrication and Characterization of the Fiber Optical Taper for a Surface Plasmon Resonance Sensor
For a fiber optical surface plasmon resonance (SPR) sensor a short part of its cladding should be removed to coat a thin layer of a metal. Usually this is problematic when an optical fiber with small core diameter is used. In this paper, a new method using µliter droplet of the HF acid for short fiber optical taper fabrication is reported. Using this method in a multi-mode optical fiber w...
متن کاملfabrication and characterization of the fiber optical taper for a surface plasmon resonance sensor
for a fiber optical surface plasmon resonance (spr) sensor a short part of its cladding should be removed to coat a thin layer of a metal. usually this is problematic when an optical fiber with small core diameter is used. in this paper, a new method using µliter droplet of the hf acid for short fiber optical taper fabrication is reported. using this method in a multi-mode optical fiber with th...
متن کاملFabrication of Crosslinkable Hollow Fiber Membranes for Pervaporation Dehydration
Integrally-skinned asymmetric Polyetherimide/Poly (vinyl alcohol) (PEI/PVA) hollow fber membranes for pervaporation dehydration were fabricated by non-solvent induced phase inversion. PVA inside the PEI matrix could be crosslinked to provide membrane performance stability during long term operation. The effects of different PEI/PVA blend ratio, external coagulant type and...
متن کاملMiniaturized fiber taper reflective interferometer for high temperature measurement.
We present an ultra-small all-silica high temperature sensor based on a reflective Fabry-Perot modal interferometer (FPMI). Our FPMI is made of a micro-cavity (approximately 4.4 microm) directly fabricated into a fiber taper probe less than 10 mum in diameter. Its sensing head is a miniaturized single mode-multimode fiber configuration without splicing. The sensing mechanism of FPMI is the inte...
متن کاملFabrication and Characterization of Polyetherimide Hollow Fiber Membrane Contactor for Carbon Dioxide Stripping from Monoethanolamine Solution
In this research, process asymmetric polyetherimide hollow fiber membranes using ethanol (0, 2 and 4 wt%) as non-solvent additive in the polymer dope via phase inversion method were fabricated. Aqueous solution of 1-methyl-2-pyrrolidine (NMP) (90%) was applied as a bore fluid to avoid inner skin layer formation and water was used as the external coagulant. The morphology of fabricated membranes...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Review of Scientific Instruments
سال: 2006
ISSN: 0034-6748,1089-7623
DOI: 10.1063/1.2239033