HIGH PROTECTION PERFORMANCE OF COATING SYSTEMS BASED ON ZINC RICH PRIMER AND FLUOROPOLYMER COATING
نویسندگان
چکیده
منابع مشابه
Effect of Molar Ratio and Resin Modification on the Protection Properties of Zinc-rich Alkali Silicate Primer
The influence of increasing the SiO2/K2O molar ratio on the electrochemical action of a waterborne potassium silicate zinc-rich coating was investigated by means of electrochemical impedance spectroscopy (EIS) and corrosion potential (Ecorr) measurements. The EIS results showed that increasing the SiO2/K2O molar ratio in the range of 3.135 to 5 by the addition of nano-SiO2 to the resins improve...
متن کاملTwo Surprises from Inorganic Zinc-rich Silicate Coating
Much of the information we are seeing at this symposium revolves around the utility of Zn rich coatings. Marine Environmental Research (MER) has been examining these coatings as the material component in a surface protective system applicable to both marine and land based needs. The nonmaterial component of this system is electrical. The way these two components interact and the surprising resu...
متن کاملDirect Electrosynthesis of Polyaniline–Fe2O3 Nanocomposite Coating on Aluminum Alloy 5052 and Its Corrosion Protection Performance
The synthesis of polyaniline- Fe2O3 nanocomposite coating on aluminum Alloy 5052 (AA5052) surface has been investigated by using the galvanostatic method. The anticorrosion performance of polyaniline-Fe2O3 coating was investigated in 3.5% NaCl solution by the open- circuit potential (OCP), Tafel polarization technique and Electrochemical Impedance Spectroscopy (EIS). The corrosion rate of polya...
متن کاملdirect electrosynthesis of polyaniline–fe2o3 nanocomposite coating on aluminum alloy 5052 and its corrosion protection performance
the synthesis of polyaniline- fe2o3 nanocomposite coating on aluminum alloy 5052 (aa5052) surface has been investigated by using the galvanostatic method. the anticorrosion performance of polyaniline-fe2o3 coating was investigated in 3.5% nacl solution by the open- circuit potential (ocp), tafel polarization technique and electrochemical impedance spectroscopy (eis). the corrosion rate of polya...
متن کاملEffect of Profile Uniformity on Coating Performance
It is necessary to control the profile of abrasive-blasted metal surfaces to a degree. But it is not necessary to maintain an exact profile on all surfaces as long as the profile falls within an acceptable range. The acceptable range is usually determined by the type of coating and total dry film thickness (dft) being applied. Generally, the profile should be 20 percent to 25 percent of the tot...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Vietnam Journal of Science and Technology
سال: 2018
ISSN: 2525-2518,2525-2518
DOI: 10.15625/2525-2518/56/3b/12871