High-Temperature Deformation Characteristics of Titanium
نویسندگان
چکیده
منابع مشابه
Deformation Characteristics of Composite Structures
The composites provide design flexibility because many of them can be moulded into complex shapes. The carbon fibre-reinforced epoxy composites exhibit excellent fatigue tolerance and high specific strength and stiffness which have led to numerous advanced applications ranging from the military and civil aircraft structures to the consumer products. However, the modelling of the beams undergoin...
متن کاملCoercivity of titanium-substituted high-temperature permanent magnets
The temperature dependence of the coercivity of Sm–Co based magnets is investigated by magnetization measurements and model calculations. The Zr-free titanium-substituted Sm–Co material exhibits a positive temperature coefficient of the coercivity (TCC) above room temperature, a reasonable hysteresis-loop shape, and an appreciable coercivity of 12.3 kOe at 500 C for the nominal composition Sm(C...
متن کاملHigh Temperature Deformation Behavior of Cr-containing Superplastic Iron Aluminide
Superplastic deformation and high temperature load relaxation behavior of coarse-grained iron aluminides with the composition of Fe-28 at.% Al have been investigated. A series of load relaxation and tensile tests were conducted at temperatures ranging from 600 to 850C. The flow curves obtained from load relaxation tests were found to have a sigmoidal shape and to exhibit stress vs. strain rate ...
متن کاملMicrostructure and High Temperature Deformation Behavior of Cast 310S Alloy
High temperature deformation behavior of cast 310S stainless steel has been investigated in this study by performing tensile and compression tests at temperatures from 900 to 1200C. Rectangular ingots of which the dimensions were 350×350×100 in millimeter were cast using vacuum induction melting. Phase equilibrium was calculated using the FactSage®, thermodynamic software and database. Thermal ...
متن کاملTitanium dioxide based high temperature carbon monoxide selective sensor
The anatase form of TiO2 has been examined for the sensing of CO and CH4 at temperatures of 873 K. Though, there were differences in the sensitivity of the anatase sensor towards CO and CH4, both gases showed considerable resistance changes. However, in the presence of lanthanum oxide and copper oxide (labeled as ALC sensor), the sensor showed minimal response towards CH4, while still exhibitin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1986
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.72.2_271