HOMs simulation and measurement results of IHEP02 cavity
نویسندگان
چکیده
منابع مشابه
MEASUREMENT AND SIMULATION RESULTS OF Ti COATED
Microwave absorbers are coated with resistive thin films. S parameters are measured before and after coating. The measured data are used to check the simulation results of software HFSS which are in good agreement with the measurement results.
متن کاملWakefields and HOMs Studies of a Superconducting Cavity Module with the CESR Beam*
Several aspects of the beam-cavity interaction were investigated in a beam test of the superconducting accelerating cavity module for the CESR upgrade: the time structure of the cavity wake potential, sampled with two bunches, the effect of the module on the total machine loss factor, and the influence of the cavity tuner position on the frequencies and damping times of coupled bunch modes. The...
متن کاملBERLinPro 7-CELL SRF CAVITY OPTIMIZATION AND HOMs EXTERNAL QUALITY FACTORS ESTIMATION
The main scope of this work is the optimization of the Superconducting Radio Frequency (SRF) accelerating cavity design for the Berlin Energy Recovery Linac Project (BERLinPro). BERLinPro shall serve as a demonstrator for 100-mA-class Energy Recovery Liniac (ERL) with CW LINAC technology. High-current operation requires an effective damping of Higher-OrderModes (HOMs) of the 1.3 GHz main-linac ...
متن کاملSUPPRESSION OF HOMs IN A MULTICELL SUPERCONDUCTING CAVITY FOR CORNELL’S ERL*
Minimization of power of higher order modes (HOMs) in a multicell cavity was done using derivatives of the parameter defining losses with respect to geometric parameters of the cavity cells. For the Cornell Energy Recovery Linac most dangerous are dipole modes causing beam break-up (BBU). As a start point of optimization the shape with minimal losses at the fundamental mode was taken. Further c...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chinese Physics C
سال: 2015
ISSN: 1674-1137
DOI: 10.1088/1674-1137/39/11/117006