Hybrid ZVS Converter with a Wide ZVS Range and a Low Circulating Current
نویسندگان
چکیده
منابع مشابه
A New ZVS-PWM Full-Bridge Converter
A full-bridge converter which employs a coupled inductor to achieve zero-voltage switching of the primary switches in the entire line and load range is described. Because the coupled inductor does not appear as a series inductance in the load current path, it does not cause a loss of duty cycle or severe voltage ringing across the output rectifier. The operation and performance of the proposed ...
متن کاملA Novel Single-stage AC/DC Converter with ZVS Characteristic
A novel single-stage AC/DC converter is proposed in this letter. The converter is designed by integrating a sepic circuit and a flyback circuit, the circuit work in the quasi-resonance state, and the switch is turned on in the zero voltage switching (ZVS) state, which decreased the switching losses of the converter Streszczenie. Opisano nowy konwerter AC/DC. Układ pracuje w stanie quasi-rezonan...
متن کاملA High Efficiency ZCS-ZVS Buck Converter with Coupled Inductor
A novel topology for a soft-switching buck dc– dc converter with a coupled inductor is proposed. The soft-switching buck converter has advantages over the traditional hardswitching converters. The most significant advantage is that it offers a lower switching loss. This converter operates under a zero-current switching condition at turn on and a zero-voltage switching condition at turn off. It ...
متن کاملA Zvs Full Bridge Resonant Inverter Based High Step down Multiple Output Converter with Wide Input Voltage Range
DC-BUS based power distribution systems with battery backup have been widely used in aerospace and telecommunication applications, where the bus voltage is usually determined by the battery. In these systems, there are many loads that need different and low operating voltages. Since the bus voltage is usually much higher than the load voltage and varies in a wide range with the stage of charge ...
متن کاملA Zero Input Current Ripple ZVS/ZCS Boost Converter with Boundary-Mode Control
In this paper, in order to achieve zero ripple conditions, the use of a ripple mirror (RM) circuit for the boost converter is proposed. The operation modes are studied and steady-state analyses performed to show the merits of the proposed converter. It is found that the proposed RM circuit technique can provide much better flexibility than the two-phase interleaved boost converter for locating ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Power Electronics
سال: 2015
ISSN: 1598-2092
DOI: 10.6113/jpe.2015.15.3.652