Hypoid gear tooth Bearing pattern analysis. (1st report. The gear dimensions for tooth bearing development).
نویسندگان
چکیده
منابع مشابه
Nonlinear Dynamics Analysis of a Gear-Shaft-Bearing System with Breathing Crack and Tooth Wear Faults
Considering backlash, time-varying mesh stiffness and radial clearance of bearing, nonlinear dynamic model of gear bearing flexible shaft system is established taking into account breathing crack in shaft and tooth wear. Nonlinear dynamic equations are solved by Runge-Kutta method. Effect of backlash, crack in shaft and tooth wear faults on the nonlinear dynamic behavior of gear-shaft-bearing s...
متن کاملPerformance analysis of generated hypoid gear based on measured tooth flank form data
Article history: Received 18 February 2013 Received in revised form 19 September 2013 Accepted 22 September 2013 Available online 24 October 2013 A method for predicting and analyzing the tooth contact pattern, vibration, and strength of a generated hypoid gear is needed to achieve a low-noise design and adequate quality control. However, it is not easy to analyze the performance of a generated...
متن کاملOptimal Modifications of Gear Tooth Surfaces
62 Management Summary In this paper a new method for the introduction of optimal modifications into gear tooth surfaces—based on the optimal corrections of the profile and diameter of the head cutter, and optimal variation of machine tool settings for pinion and gear finishing—is presented. The goal of these tooth modifications is the achievement of a more favorable load distribution and reduce...
متن کاملOn tribological design in gear tooth contacts
The correct tribological design will have a considerable effect on a gear’s service life and efficiency. The purpose of this thesis is to clarify the impact of variation in the gear tooth flank tribological system on the gear contact load capacity – to increase the understanding of how surface topography and lubricant interact. In this thesis the variation in surface topography inherent in the ...
متن کاملAnalysis of Mixed Lubrication Effects in Simulated Gear Tooth Contacts
The paper presents results obtained using a transient analysis technique for point contact elastohydrodynamic lubrication (EHL) problems based on a formulation that couples the elastic and hydrodynamic equations. Results are presented for transverse ground surfaces in elliptical point contact that show severe film thinning and asperity contact at the transverse limits of the contact area. This ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1990
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.56.744