Low pressure sintering of sialon using different sintering additives
نویسندگان
چکیده
منابع مشابه
Low Temperature Sintering Additives for Silicon Nitride
This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....
متن کاملLow-Temperature Sintering of Alumina with Liquid-Forming Additives
Simultaneous application of colloidal processing and liquidforming additives to alumina resulted in a sintered density of >99% in 1 h at a temperature as low as 1070°C for a commercial high-purity alumina powder at a total dopant level of 2 mol%. The additives were 0.9% CuO + 0.9% TiOz + 0.1% B 2 0 3 + 0.1% MgO. At higher temperatures or after prolonged sintering, the doped alumina ceramic deve...
متن کاملThe Effect of Precursor Composition and Sintering Additives on the Formation of β-Sialon from Al, Si and Al2O3 Powders
A study was performed to investigate the effect of increasing the Al or Al2O3 precursor content, above the stoichiometric amount, on the formation of β-sialon by pressureless sintering of Al, Si and Al2O3 powders in flowing nitrogen gas. The effect of adding Y2O3 or Fe to the precursor mixture, on the β-sialon formation, was also studied. The phase morphology and yield produced by the various c...
متن کاملDemystifying the role of sintering additives with “complexion”
he role of additives has long been a theme in sintering science. Recently, it has been discovered that ceramics may contain multiple different rain boundary phases (complexions) that are chemically induced by certain additives. These complexions are useful in explaining a number of nomalous phenomena associated with sintering, such as abnormal grain growth. The current work investigates how tra...
متن کاملSintering properties of hydroxyapatite powders prepared using different methods
In the present work, the sintering behaviour of HA particles prepared via the wet precipitation method (HAp) and wet mechanochemical technique (HAwm) was investigated. The sintering behaviour of a commercial HA powder (HAc) was also studied for comparison purpose. All the three powders were characterised in terms of particle size, Ca/P ratio and crystal size. Green samples were prepared and sin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2008
ISSN: 1348-6535,1882-0743
DOI: 10.2109/jcersj2.116.130