Machining Condition Function Ruling Critical Phenomenon in Cutting Behavior of Abrasive Stone (2nd Report)
نویسندگان
چکیده
منابع مشابه
interpersonal function of language in subtitling
translation as a comunicative process is always said to be associated with various aspects of meaning loss or gain. subtitling as a mode of translating, due to special discoursal and textual conditions imposed upon it, is believed to be an obvious case of this loss or gain. presenting the spoken sound track of a film in writing and synchronizing the perception of this text by the viewers with...
15 صفحه اولCellular Automata Modelling of Micro Abrasive Machining
This paper presents the use of Cellular Automata (CA) for modelling micro abrasive machining. A onedimensional CA was initially used to model the workpiece, as having different heights, to represent the roughness; and the forces from the abrasive grits were modelled to randomly erode the workpiece, as such smoothening out and polishing the surface. The modelling was then extended further to two...
متن کاملNeural Network Modeling of Abrasive Flow Machining
This paper discusses the preliminary development of a neural network-based process monitor and off-line controller for abrasive flow machining of automotive engine intake manifolds. The process is only observable indirectly, yet the time at which machining achieves the specified air flow rate must be estimated accurately. A neural network model is used to estimate when the process has achieved ...
متن کاملMaterial Removal Mechanisms in Abrasive Flow Machining
Abrasive flow machining (AFM) is a process for the production of excellent surface qualities of inner profiles that are difficult to access and outside edges, as well as for deburring and edge rounding. The grinding medium used in AFM consists of a polymer fluid, the so-called base, in which the abrasive grains are bound. The grinding medium is pressed along the contours at a defined pressure a...
متن کاملAbrasive machining of advanced technical ceramics
The high cost of ceramic components can be associated with complex and time-consuming postmachining, which is currently done by using abrasive machining processes. The IWF and Fraunhofer-IPK are undertaking research activities in the field of abrasive machining which aim at developing and optimizing technologies to expand the application field and to increase productivity of high-performance ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1981
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.47.166