Magneto-Impedance Effect in Amorphous Wire Magnetized with an Asymmetrical Current.
نویسندگان
چکیده
منابع مشابه
A Magnetic Sensor with Amorphous Wire
Using a FeCoSiB amorphous wire and a coil wrapped around it, we have developed a sensitive magnetic sensor. When a 5 mm long amorphous wire with the diameter of 0.1 mm was used, the magnetic field noise spectrum of the sensor was about 30 pT/ÖHz above 30 Hz. To show the sensitivity and the spatial resolution, the magnetic field of a thousand Japanese yen was scanned with the magnetic sensor.
متن کاملEffect of the asymmetrical rolling process on the micro hardness and microstructure of brass wire
Current experimental investigation deals with the effects of asymmetrical rolling parameters on the inhomogeneity, microstructure, mechanical, and geometrical properties of rolled brass wire. Toward this end, a roll machine with three different roll radii ratios was set up. The asymmetrical conditions are arranged using three different sets of rolls with different diameters that result into dif...
متن کاملMagneto-transport Spectroscopy on a Quantum Wire
One-dimensional structures are expected to show unique electronic transport behavior as a consequence of the Coulomb interaction between carriers. A considerable number of theoretical predictions remain largely untested by experiment due to a lack of a suitable one-dimensional wire. Using a new crystal growth technique a unique tube-like structure with a cross section of 25 nm x 25 nm has been ...
متن کاملWire Measurement of Impedance of an X-band Accelerating Structure
Several tens of thousands of accelerator structures will be needed for the next generation of normal conducting linear colliders known as the GLC/NLC (Global Linear Collider/Next Linear Collider). To prevent the beam being driven into a disruptive BBU (Beam Break-Up) mode or at the very least, the emittance being significantly diluted, it is important to damp down the wakefield left by driving ...
متن کاملAn Experimental Investigation of Magnetized Water Effect on Formation Damage
In oil industries, water injection into oil reservoirs for pressure maintenance, oil displacement, and oil recovery is a common technique. Formation damage during water injection is a major problem in this process. Formation damage from the incompatibility of formation water (FW) and injection water (IW) causes a reduction in the permeability around the injection wells. Therefore, it is necessa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1995
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.19.485