Mechanical Characterization and Micro-Wear of FeB-Fe<sub>2</sub>B Layers on Boriding AISI D2 and AISI 4340 Steels
نویسندگان
چکیده
The mechanical behavior and wear of the different hardened phases with bore-induced changes in AISI 4340 D2 steels were investigated. hardness modulus elasticity measured by nanoindentation values obtained for layers steel 18 GPa 325 Fe2B boride phase, 20 360 FeB respectively. presented mainly phase. It was then possible to analyze coefficient friction phase a range 0.04 0.06. presents two layer being higher test than Fe2B, vary from 0.065 0.075. These parameters micro-wear tests. No adhesion failures observed after sliding tests interface layers. Cracks much more frequent.
منابع مشابه
Mechanical Properties of Boronized AISI 316, AISI 1040, AISI 1045 and AISI 4140 Steels
In this study, some mechanical properties of borided and unborided four steels were investigated. Boronizing of steels was performed by powder pack method at 1210 K for 4 h. The hardness of borides, boride layer thickness and room temperature tensile properties were measured and it was observed that hardness and tensile properties strongly depend on chemical composition of steels. In addition, ...
متن کاملMechanical Characterization of Friction Welded AISI 304 Steels
There are many industries where austenitic stainless steel needs to be welded specially in power generation industries. Unfortunately the austenitic stainless welding has several fabrication and metallurgical drawbacks when welded by using conventional fusion welding methods, which can often leads to in-service failure. The most pronounced fabrication faults are hot cracks due to inadvertent us...
متن کاملComparison of Hardness and Wear Behaviour of Boronized and Carburized AISI 8620 Steels
In this study, the hardness and wear behaviour of carburized and boronized AISI 8620 steels have been studied. The boronizing treatment increased the hardness of AISI 8620 steels from 395 HV0.1 to a maximal 1610 HV0.1 compared to the carburized steels and also significantly improved its wear behaviour. From obtained results, it can be concluded that boronizing is very effective surface hardenin...
متن کاملMicro Laser Welding of AISI 430 Ferritic Stainless Steel: Mechanical Properties, Magnetic Characterization and Texture Evolution
In the present work, a high power Nd:YAG laser has been employed to weld AISI 430 ferritic stainless steel thin sheets. Optical microscopy was used to study the microstructural evolutions during laser welding. Tensile test and microhardness measurement were employed in order to investigate the mechanical behaviors of welds. Also, vibrational sample magnetometry was used for characterizing magne...
متن کاملImproving the Microstructure, Mechanical and Magnetic Properties of AISI 4340 Steel Using the Heat Treatment Process
AISI 4340 steel is one of the super strong steels that can be selected for different applications. By designing the proper cycles of heat treatment, the optimum microstructure and properties of this steel can be achieved. In this study, different heat treatment cycles were introduced to achieve the optimum microstructure and improve the mechanical and magnetic properties of AISI 4340 steel. The...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Sciences and Applications
سال: 2021
ISSN: ['2153-1188', '2153-117X']
DOI: https://doi.org/10.4236/msa.2021.127022