Micro Cutting Characteristics of Pig Cortical Bone under Micro Cutting
نویسندگان
چکیده
منابع مشابه
Fiber Laser for Micro Cutting of Metals
The fiber laser concept is proven technology for telecom applications where its single mode performance and reliability is essential. Newer generation diode-pumped fiber lasers are using pump diodes especially developed for telecom applications and therefore offer excellent controllability of the laser pulse length and pulse frequency. In recent years the output power of fiber lasers has increa...
متن کاملAn Approach on Micro-Cutting (Deburring) Process
This paper presents an mathematical model that establishes the relation between the relevant cutting process parameters and surface quality, cutting forces and rate removal, in deburring process. The construction of cutting tool that one use in determining the experimental data is also presented. The mathematical model is determined by using multifactorial analysis. Directions towards the optim...
متن کاملFuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملMicro Cutting Simulation of Abrasive Grains in the Grinding Process
In the current work we present approach to study the mechanism of the cutting of abrasive grains in the grinding wheel using finite element analysis (FEA). The simulation process is done by separating two abrasive grains from the grinding wheels and the microprocess of material removal in the case of surface grinding is simulated. Modelling was done on the workpiece steel S-7 and material grain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering, Contributed Papers
سال: 2005
ISSN: 1881-8722,1348-8724
DOI: 10.2493/jspe.71.1151