Microstructure evolution and high temperature resistance of Ti6Al4V/Inconel625 gradient coating fabricated by laser melting deposition
نویسندگان
چکیده
منابع مشابه
Effect of Cobalt on Microstructure and Wear Resistance of Ni-Based Alloy Coating Fabricated by Laser Cladding
Ni-based alloy powders with different contents of cobalt (Co) have been deposited on a 42CrMo steel substrate surface using a fiber laser. The effects of Co content on the microstructure, composition, hardness, and wear properties of the claddings were studied by scanning electron microscopy (SEM), an electron probe microanalyzer (EPMA), X-ray diffraction (XRD), a hardness tester, and a wear te...
متن کاملComparison of Microstructure and Mechanical Properties of Scalmalloy® Produced by Selective Laser Melting and Laser Metal Deposition
The second-generation aluminum-magnesium-scandium (Al-Mg-Sc) alloy, which is often referred to as Scalmalloy®, has been developed as a high-strength aluminum alloy for selective laser melting (SLM). The high-cooling rates of melt pools during SLM establishes the thermodynamic conditions for a fine-grained crack-free aluminum structure saturated with fine precipitates of the ceramic phase Al₃-Sc...
متن کاملNumerical and Experimental Study of Effect of Scan Velocity in Laser Forming by Temperature Gradient Mechanism
In this paper the process of laser forming has been investigated using an analytical and an experimental method for three levels scans velocity. A coupled analysis has been performed in ANSYS®. Also in order to prove the predictive methods, experiments on thin sheet metals have been done when a laser of a fair power was used. Before done, experiments were designed with full factorial chosen as ...
متن کاملResearch on High Layer Thickness Fabricated of 316L by Selective Laser Melting
Selective laser melting (SLM) is a potential additive manufacturing (AM) technology. However, the application of SLM was confined due to low efficiency. To improve efficiency, SLM fabrication with a high layer thickness and fine powder was systematically researched, and the void areas and hollow powders can be reduced by using fine powder. Single-track experiments were used to narrow down proce...
متن کاملMicrostructure Evolution and Microstructural Characteristics of Al–Mg–Si Aluminum Alloys Fabricated by a Modified Strain-Induced Melting Activation Process
A modified strain-induced melting activation (SIMA) process is shown to improve high-temperature formability. The microstructural characteristics of the spheroidized grains of SIMA-processed alloys affect high-temperature formability. The effects of hot extrusion parameters and chemical composition on the evolution of spheroidized grains were investigated using several 6xxx series aluminum allo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials & Design
سال: 2020
ISSN: 0264-1275
DOI: 10.1016/j.matdes.2020.108644