Modeling for non isothermal cavitation using 4-equation models
نویسندگان
چکیده
منابع مشابه
Modified Kremser Equation for Plate Type Gas Absorberin Non-Isothermal Operation (RESEARCH NOTE).
For non-isothermal operation in plate type gas absorber, the temperature changes and number of ideal trays can be determined with recourse to graphical method. In this paper there is an analysis illustrating that a Modified Kremser Equation can be used for plate type gas absorber in non-isothermal operation.
متن کاملGeneralised isothermal models with strange equation of state
We consider the linear equation of state for matter distributions that may be applied to strange stars with quark matter. In our general approach the compact relativistic body allows for anisotropic pressures in the presence of the electromagnetic field. New exact solutions are found to the Einstein-Maxwell system. A particular case is shown to be regular at the stellar centre. In the isotropic...
متن کاملIsothermal and Non-isothermal Methods
a comparison was made between the experimental non-isothermal a vs. t curves and those calculated on the basis of a previous isothermal study. It was observed that for low heating rates, when the "thermal lag" is negligible, the dynamic measurements are in good agreement with the isothermal ones. Furthermore, for process (I), two mathematical methods proposed for the interpretation of the non-i...
متن کاملKinetic Modeling of Isothermal or Non-isothermal Adsorption in a Pellet: Application to Adsorption Heat Pumps
Understanding the interaction between a fluid and a solid phase is of fundamental importance to the design of an adsorption process. Because the heat effects associated with adsorption are comparatively large, the assumption of isothermal behavior is a valid approximation only when uptake rates are relatively slow. In this article, we propose to determine when it is needed to choose the isother...
متن کاملModeling of Non-isothermal Reacting Flow in Fluidized Bed Reactors
Abstract: We investigate a prototype concept of a back-up electricity device where we use liquid formic acid (FA) to produce a mixture of carbon dioxide (CO2) and hydrogen (H2) which is used in a PEM fuel cell, Fig. 1. In the fluidized bed reactor the liquid FA is decomposed to a gaseous mixture of CO2 and H2 in the presence of microscopic floating solid catalytic particles. We describe the sys...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Heat and Mass Transfer
سال: 2014
ISSN: 0017-9310
DOI: 10.1016/j.ijheatmasstransfer.2014.04.065