Morphological and Mechanical Investigation of Double-Layer Reciprocal Structures
نویسندگان
چکیده
منابع مشابه
Morphological and mechanical investigation of double layer reciprocal structures
From a technological point of view, reciprocal structures have the advantage of simplifying considerably connections in the sense that members are connected only by pairs. This constructional advantage has two main consequences: technological constrains are replaced by geometrical constrains and bending moments are increased through the non convergence of members to nodes with multiple connecti...
متن کاملMechanical Properties and Microstructural Evolution of Ta/TaNx Double Layer Thin Films Deposited by Magnetron Sputtering
Crystalline tantalum thin films of about 500nm thickness were deposited on AISI 316L stainless steel substrate using magnetron sputtering. To investigate the nano-mechanical properties of tantalum films, deposition was performed at two temperatures (25°C and 200°C) on TaNx intermediate layer with different N2/Ar flow rate ratio from 0 to 30%. Nano-indentation was performed to obtain the mechani...
متن کاملdetermination of some physical and mechanical properties red bean
چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...
15 صفحه اولInvestigation of structural, morphological and dynamic mechanical properties of unvulcanized PDMS/silica compound
In this study, the interaction between the silica filler and polydimethylsiloxanes (PDMS) was investigated from the aspects of the bound rubber and morphological characterization. With special attention to the dynamic properties, the dynamic test was conducted by dynamic shear rheometer. The results show that the modified fillers disperse uniformly within PDMS matrix without aggregation and con...
متن کاملPhotonic band gaps with layer-by-layer double-etched structures
Periodic layer-by-layer dielectric structures with full three-dimensional photonic band gaps have been designed and fabricated. In contrast to previous layer-by-layer structures the rods in each successive layer are at an angle of 70.5° to each other, achieved by etching both sides of a silicon wafer. Photonic band-structure calculations are utilized to optimize the photonic band gap by varying...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nexus Network Journal
سال: 2014
ISSN: 1590-5896,1522-4600
DOI: 10.1007/s00004-014-0185-9