Morphology of Cu Particle during High-Temperature Deformation in Cu-added Ferritic Stainless Steels
نویسندگان
چکیده
منابع مشابه
High-Alloy Ferritic Steels: Martensitic Stainless Steels, Precipitation Hardening (code 1810)
This report may be updated and revised periodically in response to the needs of the technical community; up-to-date versions can be requested from the editors at the address given below or downloaded at http://www.ca.sandia.gov/matlsTechRef/. The content of this report will also be incorporated into a Sandia National Laboratory report (SAND2008-1163); the most recent version can be obtained fro...
متن کاملThermal Fatigue Behavior of 400 Series Ferritic Stainless Steels
In this study, thermal fatigue properties of 400 series ferritic stainless steels have been evaluated in the temperature ranges of 200-800C and 200-900C. Systematic methods for control of temperatures within the predetermined range and measurement of load applied to specimens as a function of temperature during thermal cycles have been established. Thermal fatigue tests were conducted under ful...
متن کاملLow-Temperature Carburization of Austenitic Stainless Steels
LOW-TEMPERATURE CARBURIZATION is a gaseous carburization process performed at atmospheric pressure, at temperatures where the kinetics of substitutional diffusion are very slow. Low-temperature carburization hardens the surface of austenitic stainless steels through the diffusion of interstitial carbon, without the formation of carbides. The surface must be activated, by modification and remova...
متن کاملAnalysis of deformation induced martensitic transformation in stainless steels
Many studies monitoring the formation of martensite during the tensile deformation of austenite report data which are, in principle, affected by both the applied stress and the resulting plastic strain. It is not clear in these circumstances whether the transformation is stress induced (i.e. the stress provides a mechanical driving force) or whether the generation of defects during deformation ...
متن کاملThermography for Characterisation of Deformation Process in Stainless Steels
It is well known that during tensile testing, a part of the mechanical work done on the specimen is transformed into heat energy. The rate of rise and maximum temperature attained depends on the nature of material, its deformation behaviour and test conditions. This paper highlights the application of thermography for characterising various stages of tensile deformation in AISI type 316 stainle...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2017
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.tetsu-2017-001