Motion analysis of digitally controlled machines
نویسندگان
چکیده
منابع مشابه
Hardware for digitally controlled scanned probe microscopes
The design and implementation of a flexible and modular digital control and data acquisition system for scanned probe microscopes ( SPMs) is presented. The measured performance of the system shows it to be capable of 1Cbit data acquisition at a lOO-kHz rate and a full l&bit output resolution resulting in less than 0.02-A rms position noise while maintaining a scan range in excess of 1 pm in bot...
متن کاملLow Power CMOS Digitally Controlled Oscillator
Here, two new designs of CMOS digitally controlled oscillators (DCO) for low power application have been proposed. First design has been implemented with one driving strength controlled delay cell and with two NAND gates used as inverters. The second design with one delay cell and by two NOR gates is presented. The proposed circuits have been simulated in spice with 0.35 μm (micrometer) technol...
متن کاملA Digitally Controlled Satellite Frequency Synthesizer
This report considers two well-known methods of frequency synthesis, the VCO approach and the modular or iterative mix-filter-divide approach from the point of view of use in the Lincoln Experimental Satellite (LES) series. System parameters are chosen and a specific implementation is described. Accepted for the Air Force Franklin C. Hudson Chief, Lincoln Laboratory Office
متن کاملEvaluation of Early Active Controlled Motion in Flexor Tendon Repair
Objectives: The objective was to determine the results of early active controlled motion in the patients rehabilitated by our new protocol. Methods: 91 fingers in 64 patients with flexor tendon repair in all zones were enrolled in a single group (quasi-experimental) clinical trial. 58 fingers in 43 patients were assessed at least three months postoperatively. Outcomes were defined using the ...
متن کاملA Digitally Controlled Amplifier With Ripple Cancellation
This paper describes a large-signal linear, multirate digital controller for, among other possible servomechanical applications, charging electric vehicle batteries. This controller permits the power amplifier to track and deliver a desired current trajectory for a wide range of loads while providing a unity-power-factor interface to the electric utility. A computationally inexpensive technique...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: PAMM
سال: 2004
ISSN: 1617-7061
DOI: 10.1002/pamm.200410045