New Fault Tolerance Method for Open-Phase PMSM
نویسندگان
چکیده
منابع مشابه
A New Method of Fault Tolerance TCP
With the rapid development of Internet, the need of high availability of data services on Internet becomes more urgent. But as one of the most useful protocol on Internet, TCP protocol software can not solve the high availability due to the failure of hardware or software on Server/Client. In this paper, we propose a new method that can implement fault tolerance TCP to improve the high availabi...
متن کاملFault Diagnosis and Fault-Tolerant SVPWM Technique of Six-phase Converter under Open-Switch Fault
In this paper, a new open-switch fault diagnosis method is proposed for the six-phase AC-DC converter based on the difference between the phase current and the corresponding reference using an adaptive threshold. The open-switch faults are detected without any additional equipment and complicated calculations, since the proposed fault detection method is integrated with the controller required ...
متن کاملCurrent Sensor Fault Reconstruction for PMSM Drives
This paper deals with a current sensor fault reconstruction algorithm for the torque closed-loop drive system of an interior PMSM. First, sensor faults are equated to actuator ones by a new introduced state variable. Then, in αβ coordinates, based on the motor model with active flux linkage, a current observer is constructed with a specific sliding mode equivalent control methodology to elimina...
متن کاملOpen-Phase Fault Tolerance Techniques of Five-Phase Dual-Rotor Permanent Magnet Synchronous Motor
Abstract: Multi-phase motors are gaining more attention due to the advantages of good fault tolerance capability and high power density, etc. By applying dual-rotor technology to multi-phase machines, a five-phase dual-rotor permanent magnet synchronous motor (DRPMSM) is researched in this paper to further promote their torque density and fault tolerance capability. It has two rotors and two se...
متن کاملDTC Method for Vector Control of 3-Phase Induction Motor under Open-Phase Fault
Three-phase Induction Motor (IM) drives are widely used in industrial equipments. One of the essential problems of 3-phase IM drives is their high speed and torque pulsation in the fault conditions. This paper shows Direct Torque Control (DTC) strategy for vector control of a 3-phase IM under opencircuit fault. The objective is to implement a solution for vector control of 3-phase IM drives whi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2019
ISSN: 2169-3536
DOI: 10.1109/access.2019.2946183