Numerical and experimental investigations of the anisotropic transformation strains during martensitic transformation in a low alloy Cr-Mo steel 42CrMo4
نویسندگان
چکیده
منابع مشابه
Experimental Study of the Transformation-Induced Plasticity in a Cr-Ni-Mo-Al-Ti Steel
This paper shows cxpcrinicn~~~l results concerning thc lnartcnsitic transcormation and the transfor1nation-in(i~1cc(I plasticity undcr multinsial loading. The matcrial investigated is a Cr-Ni-Mo-Al-Ti steel, which is suhrnitlcd to :I y--)cr.' nlartcnsitic phasc: transformation undcr an applicd strcss. The specimens are thin tubes loadcd in ~cnsion-~orsion. The ~csts wcrc specially dcsigncd to p...
متن کاملMartensitic Transformation and Residual Stresses after Thermomechanical Treatment of Heat Treatable Steel 42CrMo4 (SAE 4140)
The influence of thermomechanical deformation on the residual stresses caused by quenching in bar shaped specimens of heat treatable steel 42CrMo4 has been investigated using a mechanical method for detemining the distribution of residual stresses of the first kind. The results obtained show that the residual stress distribution after quenching is dected by the strengthening and softening of th...
متن کاملMechanism of Bainite Transformation in Fe-Cr-Mo-V-Ti-C Steel
The kinetics and mechanism of bainite transformation have been studied in Fe-Cr-Mo-V-Ti-C steel high speed dilatometry backed by thermodynamic analysis. The complete transformation of austenite, however, has not occurred at any reported temperature. Obtained results confirm the incomplete reaction phenomenon with the cessation of the bainite transformation well before the paraequilibrium is ach...
متن کاملExperimental Studies on the Microstructure and Hardness of Laser Transformation Hardening of Low Alloy Steel
An experimental investigation with Nd:YAG laser system was carried out to study the effects of laser hardening process parameters on the microstructure and hardness during laser hardening of EN25 steel. The laser beam is allowed to scan on the surface of the work piece by varying the laser beam power (750–1250 W) and travel speed (500–1000 mm/min) of the work table. The microstructural features...
متن کاملcompactifications and representations of transformation semigroups
this thesis deals essentially (but not from all aspects) with the extension of the notion of semigroup compactification and the construction of a general theory of semitopological nonaffine (affine) transformation semigroup compactifications. it determines those compactification which are universal with respect to some algebric or topological properties. as an application of the theory, it is i...
15 صفحه اولذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2017
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2017.10.944