Optimization of cutting inserts geometry using DEFORM-3D: Numerical simulation and experimental validation
نویسندگان
چکیده
منابع مشابه
Optimization of Cutting Insert Geometry Using Deform-3d: Numerical Simulation and Experimental Validation
In this research work an attempt has been made to minimize flank wear of uncoated carbide inserts while machining AISI 1045 steel by finite element analysis. Tool wear is the predominant factor that causes poor surface finish and is responsible for the dimensional accuracy of the machined surface. The quality of component produced decides the effectiveness and competitiveness of any manufacturi...
متن کاملNumerical simulation of effects of machining parameters and tool geometry using DEFORM-3D: Optimization and experimental validation
This research work focusses on optimization of machining and geometrical parameters during turning AISI 1045 steel using carbide cutting tool insert, by Finite Element Analysis and Taguchi’s Technique. Three levels of cutting speed, feed rate, depth of cut, cutting insert shape, relief angle and nose radius are chosen. A suitable L18 Orthogonal array is selected based on Taguchi’s Design of Exp...
متن کاملOptimization of Fan Geometry for Urban Train Traction Motors using Coupled Numerical Electromagnetic and Thermal Analysis
One of the most important parameters in designing electrical motors is heat generation by the motor and the way it is dissipated. Temperature rising reduce efficiency and reliability of traction motors and leads to failure. In this paper, an urban train traction motor in a 3D computational fluid dynamics (CFD) simulation has been investigated. Maxwell software for electromagnetic simulation and...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Robotic Deformable Object Cutting: From Simulation to Experimental Validation*
In this paper, investigations into the robotic cutting of soft deformable materials are discussed. A force vision cooperative controller is proposed to deal with the object flexibility and uncertain modeling parameters. The control scheme is firstly tested within a simulator environment and then validated on an experimental cell. The construction of the simulator is described and the interactio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Simulation Modelling
سال: 2012
ISSN: 1726-4529
DOI: 10.2507/ijsimm11(2)1.200