Positron Annihilation and XRD Studies on Deformed Al-Alloys with Low Concentration of Mg

Effect of carbon on copper precipitation in deformed Fe-based alloys studied by positron annihilation spectroscopy

The role of deformation-induced defects and carbon addition on the copper precipitation during aging at 550 o C is investigated in high-purity Fe-Cu-B-N-C alloy samples by Coincidence Doppler Broadening. In samples with 0% and 8% cold pre-strain, the influence of tensile pre-deformation on the precipitation kinetics of copper is studied. The deformationinduced defects are found to enhance the C...

Precipitation Hardening of Al–Si–Mg Alloys

Positron Annihilation Lifetime in situ Study of Deformed Polyolefin Elastomers

The positron annihilation lifetime spectroscopy was used to investigate the free volume hole size of ethylene octane copolymers as a function of deformation in the range from 0 to 110% in steps of 10%. For each degree of deformation a series of 5–6 positron annihilation lifetime spectra was collected in situ. All spectra of a given series were analysed simultaneously. They were resolved into th...

EXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS

Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...

Melt Protection of Mg-Al Based Alloys

This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...