Problems of Bainitic Transformation and Microstructures in Low Carbon Steels
نویسندگان
چکیده
منابع مشابه
The Effects of Cr and Al Addition on Transformation and Properties in Low-Carbon Bainitic Steels
Three low-carbon bainitic steels were designed to investigate the effects of Cr and Al addition on bainitic transformation, microstructures, and properties by metallographic method and dilatometry. The results show that compared with the base steel without Cr and Al addition, only Cr addition is effective for improving the strength of low-carbon bainitic steel by increasing the amount of bainit...
متن کاملStrong Bainitic Steels by Continuous Cooling Transformation
Using metallurgical models, three steels were designed to obtain carbide-free bainitic structures in the as-rolled condition. Experimental castings were hot-rolled in a pilot mill and their austenite decomposition kinetics were measured using dilatometry. Tensile and Charpy impact properties were measured and the microstructures were characterised using X-ray diffractometry, optical and scannin...
متن کاملEffect of Mo Content on Microstructure and Property of Low-Carbon Bainitic Steels
In this work, three low-carbon bainitic steels, with different Mo contents, were designed to investigate the effects of Mo addition on microstructure and mechanical properties. Two-step cooling, i.e., initial accelerated cooling and subsequent slow cooling, was used to obtain the desired bainite microstructure. The results show that the product of strength and elongation first increases and the...
متن کاملAustenite films in bainitic microstructures
Bainitic microstructures in which fine platelets offerrite are intimately mixed with films of austenite are known to exhibit good combinations of strength and toughness. It isfound that the thickness of these austenitefilms can be estimated by assuming that the carbon diffusion field around an existing plate offerrite prevents the close approach of another parallel plate. This is because the re...
متن کاملHigh-Strength Bainitic Steels
With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1991
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.77.10_1544