Process simulation and experimental validation of Hot Metal Gas Forming with new press hardening steels
نویسندگان
چکیده
منابع مشابه
Investigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملInvestigation of fluid flow and heat transfer in tube hot metal gas forming process
In this study, hot metal gas forming process of AA6063aluminumtubeis studied with a focus on heat transfer of both fluid and solid phases numerically. An experimental study is simultaneously conducted to validate the numerical method. Some of the most important outputs of the present study, are velocity distribution of fluid inside the tube as well as the fluid in the gap between tube and matri...
متن کاملNumerical study on the effect of input variations on bulge height in hot tube metal gas forming process
.Hot metal gas forming of tubes can be used in various industries such as automotive and aerospace industries. In this process tube is formed at elevated temperatures, by using gas instead of fluid pressure. Lower required pressure and low power are its advantages in comparison to hydroforming process. In this paper, a hot metal gas bulging process of an aluminum alloy tube has been investigate...
متن کاملNumerical study on the effect of hammering pressure on thickness reduction in hot tube metal gas forming process
Nowadays, light weight and high strength metals are being used in various industries such as automotive and aerospace. Using aluminum-magnesium alloys is an efficient way to reduce the weight of a specific part. These alloys have poor formability in room temperature thus they should be formed at elevated temperature. Warm hydroforming and hot metal gas forming are conventional methods to form ...
متن کاملExperimental and Numerical Studies of Sheet Metal Forming with Damage Using Gas Detonation Process
Gas detonation forming is a high-speed forming method, which has the potential to form complex geometries, including sharp angles and undercuts, in a very short process time. Despite many efforts being made to develop detonation forming, many important aspects remain unclear and have not been studied experimentally, nor numerically in detail, e.g., the ability to produce sharp corners, the effe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2017
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/896/1/012051