Quantification of microdamage phenomena during tensile straining of high volume fraction particle reinforced aluminium
نویسندگان
چکیده
منابع مشابه
TENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملEffect of Particle Volume Fraction on the Tensile Properties of Composite Al6061/SiC Materials by Hot Extrusion
In the present study the effect of phase volume fraction on the reinforcement of microstructure and tensile properties of composite extrusion process Al6061/SiC has been studied. For this purpose, the base alloy Al6061 using pure aluminum ingots, silicon, of Al-50% Mg, Al-10% Cr and a thin copper rod was prepared. Next, the composite Al6061/5% SiC, Al6061/10% SiC, Al6061/15% SiC and Al6061/20% ...
متن کاملEffect of particle size and volume fraction on tensile properties of fly ash/polyurea composites
Fly ash, which consists of hollow particles with porous shells, was introduced into polyurea elastomer. A one-step method was chosen to fabricate pure polyurea and the polyurea matrix for the composites based on Isonate® 2143L (diisocyanate) and Versalink® P-1000 (diamine). Scanning electron microscopy was used to observe the fracture surfaces of the composites. Particle size and volume fractio...
متن کاملDetailed Microstructural Evolutions of TWIP Steel During Tensile Straining: In situ SEM Observations
Microstructural evolutions of twinning induced plasticity (TWIP) steel during tensile straining were investigated by in situ SEM observations. The results indicated that slip lines and mechanical twins as well as surface relief were increased with increasing strain, resulting in a stepped surface. Additionally, these deformation mechanisms could change the shape of each grain via shear and rota...
متن کاملRoller Burnishing of Particle Reinforced Aluminium Matrix Composites
Energy and resource efficient systems often demand the use of light-weight materials with a specific combination of properties. However, these requirements usually cannot be achieved with homogeneous materials. Consequently, composites enabling tailored properties gain more and more importance. A special kind of these materials is aluminium matrix composites (AMCs), which offer elevated strengt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2001
ISSN: 1359-6454
DOI: 10.1016/s1359-6454(00)00334-7