Recovery Processes during Creep of Fe-0.75% Mn
نویسندگان
چکیده
منابع مشابه
Recovery Processes during Creep of Fe-0.75%Mn
steady state creep of the alloy was in a thermodynamical steady state, (2) which configuration of the dislocation network was contributing to the creep strength, and (3) which change in the dislocation network was the cause of the creep recovery. Specimens were furnace-cooled under stress and then observed by transmission electron microscopy. The creep stress was reduced during the test and the...
متن کاملKinetics of Austenite Recrystallization during the Annealing of Cold-rolled Fe-Mn-Al-C Steel
In the current study, the recrystallization behavior of 75% cold-rolled Fe-22Mn-10Al-1.4C steel during annealing at 750, 770, 790, 810, and 830°C was studied. X-ray diffraction patterns and optical microscopy were used to characterize microstructures. The Vickers Micro-hardness test was used to characterize recrystallization kinetics during annealing. Johnson-Mehl-Avrami-Kolmogorov (JMAK) model...
متن کاملGrowth and Magnetic Oscillatory Exchange Coupling of Mn/Fe(001) and Fe/Mn/Fe(001)
The magnetic ordering and the interlayer exchange coupling in Mn and Fe/Mn wedge structures grown epitaxially on Fe(001) whisker substrates were investigated using scanning electron microscopy with polarization analysis (SEMPA). In bare Mn/Fe(001) samples, the magnetization of the top Mn layer is collinear with the Fe magnetization, and oscillates between ferromagnetic and antiferromagnetic ali...
متن کاملTransformation-Induced Creep and Creep Recovery of Shape Memory Alloy
If the shape memory alloy is subjected to the subloop loading under the stress-controlled condition, creep and creep recovery can appear based on the martensitic transformation. In the design of shape memory alloy elements, these deformation properties are important since the deflection of shape memory alloy elements can change under constant stress. The conditions for the progress of the marte...
متن کاملCatalytic oxidation of toluene over LaBO3 (B= Fe, Mn and Co) and LaCo0.7B′0.3O3 (B′= Fe and Mn) perovskite-type
In this paper, LaBO3 perovskite type catalyst formulations were prepared by sol-gel auto combustion method using citric acid as the fuel. Activity of catalysts was tested in catalytic oxidation of toluene as a model of volatile organic compounds. LaCoO3 perovskite formulation showed the highest activity among LaBO3 (Fe, Mn and Co) perovskite catalysts. So, LaCoO3 perovskite based catalyst was s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1968
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.9.120