Reinforcement Size Dependence of Load Bearing Capacity in Ultrafine-Grained Metal Matrix Composites
نویسندگان
چکیده
منابع مشابه
Corrosion resistance of Si-Al-bearing ultrafine-grained weathering steel.
In the Ultra-steel project at the National Institute for Materials Science (NIMS), which run from 1996 to 2005, high-Si-Al-content ultrafine-grained (UFG) weathering steel was developed by grain refinement and weathering guidance. It was found that this steel has excellent strength, toughness and corrosion resistance. Samples were prepared by multi pass warm rolling at temperatures between 773 ...
متن کاملhertzian load-bearing capacity of hybrid and nano-hybrid resin composites stored dry and wet
abstract statement of problem: hertzian indentation test has been proven to be an efficient and reliable alternative upon vickers hardness test. this method has been used to test dental ceramics, amalgams, glass ionomers and luting cements.there is limited published information about the load-bearing capacity of resin composites using hertizian indentation test. objectives: to investigate the...
متن کاملTribocorrosion in Metal Matrix Composites
One of the biggest motivations behind the development of the metal matrix composites (MMCs) is the improvement of the mechanical wear resistance of the unreinforced metallic matrix material mainly by the load-bearing effect of the hard reinforcement phases. However, in a large number of applications, MMCs are also required to operate in intimate contact with aqueous environments, which may lead...
متن کاملBasics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgical and Materials Transactions A
سال: 2017
ISSN: 1073-5623,1543-1940
DOI: 10.1007/s11661-017-4186-7