Reinforcement to concrete bond strength: a comparison between normal concrete and various types of concrete

نویسندگان

چکیده

Abstract This paper describes the bond strength comparison between concrete and reinforcement with several types of concrete. The studied were normal (NC), Self-Compacting Concrete (SCC), High-Volume Fly Ash (HVFAC), (HVFA-SCC). Research data obtained from previous studies. by testing reinforced beam a lap splice in tensile moment area. Bond values normalized dividing square root grade. Then use to formulate relationship length diameter ratio (ls/db) for both SCC. From relationship, we can compare NC SCC is higher than NC. HFVAC HVFA-SCC also SCC, so that reduce need splice.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Bond of Reinforcement in High-Strength Concrete

This paper describes an examination of the development of tension lap splices in high-strength concrete and the applicability of the restriction in the ACI 318 code where the values of √fc′ used to calculate development length shall not exceed 100 psi. The focus is on the development of splices with Grade 60 epoxy-coated and uncoated bars in normalweight concrete. A summary of the behavior of b...

متن کامل

Effect of the Concrete Strength on the Concrete-Steel Bond in Concrete Filled Steel Tubes

In this study, the concrete-steel bond strength of concrete filled cylindrical steel tubes has been experimentally investigated. 22 short, high strength and normal concrete filled circular steel tubes were tested. Push-out test was carried out as the common method to evaluate the bond carrying capacity. Four different concrete mixes were used in preparing the specimens. The steel tubes were w...

متن کامل

Bond Strength of Hot – Dip Galvanized Reinforcement (b500b) with Concrete

P. Pokorný, D. Dobiáš, M. Vokáč – Czech Technical University – Klokner Institute, Prague, Czech Republic This paper evaluates the effect of initial corrosion damage to the surface of the hot dip galvanized steel coating in fresh concrete on its final bond strength. The tests were performed on uncoated and hot-dip galvanized ribbed reinforcements. The measurement of bond stress (τm) according to...

متن کامل

A Study on Behaviour of Normal Strength Concrete and High Strength Concrete Subjected to Elevated Temperatures

Cement concrete is a complex mixture of different materials. Behaviour of concrete depends on its mix proportions and constituents when it is subjected to elevated temperatures. Principal effects due to elevated temperatures are loss in compressive strength, loss in weight or mass, change in colour and spall of concrete. The experimental results of normal concrete and high strength concrete sub...

متن کامل

Bond of reinforcement in polymer concrete

Polymer concrete, a composite material in which the binding material is some type of polymer, is being used more widely in the construction industry. Polymer concretes can also contain steel reinforcing rebars; therefore, the rate of adhesion between polymer concrete and reinforcing steel must be determined. Our study investigated the extent and behaviour of adhesion in the case of reinforcing ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of physics

سال: 2022

ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']

DOI: https://doi.org/10.1088/1742-6596/2190/1/012028