Remediation of Chromium-Contaminated Soil using blast Furnace Slag
نویسندگان
چکیده
منابع مشابه
Soil Stabilisation Using Ground Granulated Blast Furnace Slag
Stabilisation is a broad sense for the various methods employed and modifying the properties of a soil to improve its engineering performance and used for a variety of engineering works. In today‟s day soil stabilisation is the major problem for civil engineers, either for construction of road and also for increasing the strength or stability of soil and reduces the construction cost. In this t...
متن کاملGround Granulated Blast Furnace Slag
1. Ground Granulated Blast Furnace Slag Ground Granulated Blast Furnace Slag (GGBFS) is a by product of the steel industry. Blast furnace slag is defined as “the non-metallic product consisting essentially of calcium silicates and other bases that is developed in a molten condition simultaneously with iron in a blast furnace.” [1] In the production of iron, blast furnaces are loaded with iron o...
متن کاملRemoval of Hexavalent Chromium in Portland Cement Using Ground Granulated Blast-Furnace Slag Powder
Using ground granulated blast-furnace slag (GGBS) under different alkaline conditions, we studied the mechanisms and extents of Cr(VI) reduction and sorption and compared them to reactions with Portland cement (PC). We also investigated the effects of mixing PC/GGBS ratios on Cr(VI) dissolution after carbonating the substrates. We observed a complete sorption and reduction of Cr(VI) to Cr(III) ...
متن کاملThe Study of Ion Adsorption by Amorphous Blast Furnace Slag
In this study, the blast furnace slag was used as absorbing bed and then, its ionic adsorption was studied. For this reason, various experimental parameters such as pH, contact time and the primary ion concentration were investigated. The remaining concentrations of ions such as; Mn2+ and Fe2+ in water were measured by atomic adsorption spectroscopy. The chemical and p...
متن کاملProperties of Foamed Mortar Prepared with Granulated Blast-Furnace Slag
Foamed mortar with a density of 1300 kg/m³ was prepared. In the initial laboratory trials, water-to-cement (w/c) ratios ranging from 0.54 to 0.64 were tested to determine the optimal value for foamed mortar corresponding to the highest compressive strength without compromising its fresh state properties. With the obtained optimal w/c ratio of 0.56, two types of foamed mortar were prepared, name...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Sustainable Development and Planning
سال: 2011
ISSN: 1743-7601,1743-761X
DOI: 10.2495/sdp-v6-n1-81-90