Residue Number System Arithmetic Assisted Coded Frequency-Hopped OFDMA
نویسندگان
چکیده
منابع مشابه
Residue Number System Arithmetic Assisted -ary Modulation
A residue number system based M -ary modem is proposed and its performance is evaluated over Gaussian channels. When one or two redundant moduli are employed, a signal-to-noise ratio gain of 1.2–2 dB was achieved for a 16-ary, 32-ary and 37-ary modem, respectively, at a bit error rate of 10 .
متن کاملResidue number system assisted fast frequency-hopped synchronous ultra-wideband spread-spectrum multiple-access: a design alternative to impulse radio
Ultra-wideband (UWB) systems having a bandwidth on the order of gigahertz have recently received wide attention both in the U.S. and in Europe. The family of UWB systems may communicate either by generating ultra-wideband signals or with the aid of innovatively combining conventional narrowband, wideband, or broadband signals. At the time of writing, UWB systems have only been implemented using...
متن کاملNew coded modulation for the frequency hoping OFDMA system
In this paper we consider reciever design for frequency hopping orthogonal frequency-division multiple access system [2]. We propose new demodultaion algorithm that can increase the number of simultaneous transmissions with the same bit error rate. This algoritm can use any statistic that can test equality of emprical distribution funcions. We have used Kolmogorov-Smirnov statistic in this pape...
متن کاملIntegrated Nanophotonics Architecture for Residue Number System Arithmetic
Residue number system (RNS) enables dimensionality reduction of an arithmetic problem by representing a large number as a set of smaller integers, where the number is decomposed by prime number factorization using the moduli as basic functions. These reduced problem sets can then be processed independently and in parallel, thus improving computational efficiency and speed. Here we show an optic...
متن کاملConstant-Coefficient FIR Filters Based on Residue Number System Arithmetic
In this paper, the design of a Finite Impulse Response (FIR) filter based on the residue number system (RNS) is presented. We chose to implement it in the (RNS), because the RNS offers high speed and low power dissipation. This architecture is based on the single RNS multiplier-accumulator (MAC) unit. The three moduli set 1 {2 ,2 ,2 1} n n n + − , which avoids 2 1 n + modulus, is used to design...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: EURASIP Journal on Wireless Communications and Networking
سال: 2009
ISSN: 1687-1499
DOI: 10.1155/2009/263695