Root Stresses of Helical Gears with Higher Pressure Angle
نویسندگان
چکیده
منابع مشابه
Influence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملAn Investigation of the Influence of Shaft Misalignment on Bending Stresses of Helical Gears with Lead Crown
Introduction Gears are highly engineered machine elements that must be designed not only to meet the torque, speed, life and noise requirements under nominal conditions, but also to compensate for adverse effects due to manufacturing errors, variations and elastic deformations of the support structures. In addition to the elastic deformation of the support and structures, manufacturing errors i...
متن کاملCooling and Lubrication of High-speed Helical Gears
Centrifugal compressor and turbine manufacturers are building machines that operate at increasingly higher speeds to reduce the size and cost of their equipment. Helical gears are commonly used to step down the speed of these machines to match nominal motor and generator speeds. The demand for higher compressor and turbine speeds has resulted in an increase in the maximum pitch line velocities ...
متن کاملAnalysis of Crack Severity on Power Density Increment of Gears
Helical gears are commonly used in industry as they have advantages of higher power density, quieter operation etc., compared to spur gears. Conventional gear design is based on various design criteria, including durability and bending strength load rating. In recent times, fracture failure modes are gaining importance in addition to conventional failure modes. Stresses due to operating fatigue...
متن کاملHelical Quantum Edge Gears in 2D Topological Insulators.
We show that two-terminal transport can measure the Luttinger liquid (LL) parameter K, in helical LLs at the edges of two-dimensional topological insulators (TIs) with Rashba spin-orbit coupling. We consider a Coulomb drag geometry with two coplanar TIs and short-ranged spin-flip interedge scattering. Current injected into one edge loop induces circulation in the second, which floats without le...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1986
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.29.3149