Simulation for material flow analysis in extrusion process
نویسندگان
چکیده
منابع مشابه
Process Analysis for Material Flow Systems
This paper describes a generic approach for analysis of internal behavior of logistic systems based on event logs. The approach is demonstrated by an example of event data from the simulation model of an automated material handling system (MHS) in a manufacturing company. The purpose of the analysis is the identification of design and operation problems and their causes, prospectively. As a res...
متن کاملHOMOTOPY PERTURBATION METHOD FOR SOLVING FLOW IN THE EXTRUSION PROCESSES
In this paper, the homotopy perturbation method (HPM) is considered for finding approximate solutions of two-dimensional viscous flow. This technique provides a sequence of functions which converges to the exact solution of the problem. The HPM does not need a small parameters in the equations, but; the perturbation method depends on small parameter assumption and the obtained results. In most ...
متن کاملCoupled analysis of material flow and die deflection in direct aluminum extrusion
The design of extrusion dies depends on the experience of the designer. After the die has been manufactured, it is tested during an extrusion trial and machined several times until it works properly. The die is designed by a trial and error method which is an expensive process in terms of time and the amount of scrap. In order to decrease the time and the amount of scrap, research is going on t...
متن کاملExtrusion of Ecc-material
An extrusion process especially designed for extrusion of pipes made from fiber reinforced cementitious materials has been developed at Department of Structural Engineering and Materials at the Technical University of Denmark. Engineered Cementitious Composite (ECC) materials have been developed in recent years at Department of Civil and Envirionmental Engineering, University of Michigan. These...
متن کاملAn Upper Bound Solution for Analysis of Twist Extrusion Process with Elliptical Die Cross-section
Twist extrusion process is a rather new route to produce highly strained materials. In this process, severe plastic deformation is applied by large shear strains. In current article, required energy for twist extrusion by use of admissible velocity field together with the upper bound technique is predicted. The proposed model is capable of considering the effect of various parameters such as di...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 2018
ISSN: 0451-5994,1880-8018
DOI: 10.2464/jilm.68.274