Sizing of Micro Cracks Using Laser-induced Broad-band Surface Waves.
نویسندگان
چکیده
منابع مشابه
Sizing of Small Surface-breaking Tight Cracks by Using Laser-ultrasonics
On the nondestructive testing, not only detection but also sizing of crack is desirable because the crack depth is one of the most important parameter to evaluate the impact of the crack to the material, to estimate crack growth and ultimately to predict lifetime of the component. Moreover, accurate measurement of the crack depth optimizes countermeasures and timing of repairs, and eventually r...
متن کاملAn Ultrasonic Technique for Sizing Surface Cracks
Rayleigh surface waves are proposed as a non-destructive method to find the depth of surface cracks. The paper describes how dynamic photoelasticity was used to develop an understanding of the subsurface interactions between R-waves and a narrow slot. A frequency analysis of the transmitted wave confirmed that the slot acts as a low pass filter for the high frequency Fourier components of the i...
متن کاملAn Inversion Procedure for Sizing Surface Cracks in Metals, Using an Open-ended Waveguide Probe
Fatigue and stress crack detection in metallic structures is of utmost importance to the in-service inspections of metallic components. Beside the crack detection, the prediction of the crack size leads to a better estimation of the useful life of the metal in service. Currently, there are several prominent nondestructive testing (NDT) techniques for detecting and sizing surface cracks in metal...
متن کاملUltrasonic Sizing of Cracks in Web Geometries
Evaluation of the critical nature of interior cracks in turbine rotor component web regions in order to assess the remaining service life of the parts requires accurate determination of the crack sizes in order to perform fracture mechanics analysis. This analysis is important both in order to retire critically defective parts and in order to return components to service if detected flaws are s...
متن کاملLaser Grooving of Surface Cracks on Hot Work Tool Steel
Repair welding (RW) with wire cladding is a common procedure to extend the in-service life of heavily loaded tool parts for die and mould industries 1-5 . The main advantages of repair welding are short downtime and cost efficiency compared to production of new tool part. Repair welding in general lowers the tool cost in the final part and enables higher added value to the die casting and injec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Atomic Energy Society of Japan / Atomic Energy Society of Japan
سال: 2001
ISSN: 0004-7120
DOI: 10.3327/jaesj.43.275