Small punch creep of Fe-Al-Cr alloy with Ce addition and its relation to uniaxial creep tests
نویسندگان
چکیده
منابع مشابه
Creep of Ni-Al and Ni-Cr-Al Superalloy Foams
The steady-state creep rate of Ni-base metallic foams, with superalloy composition (in wt. pct) Ni7.8∼9.1Al (relative density, ρ = 2.5-2.6) and Ni-13.5∼16.6Cr-5.1∼8.9Al (ρ = 2.8∼3.0), was measured under a range of temperatures (680∼825°C) and applied stresses (0.1∼0.3 MPa), and compared with that of NiAl intermetallic foams (ρ = 5.3). The stress exponent and activation energy are within the exp...
متن کاملEffect of Mg addition on the creep and yield behavior of an Al–Sc alloy
The relationships between microstructure and strength were studied at room temperature and 300 °C in an Al–2 wt% Mg–0.2 wt% Sc alloy, containing Mg in solid-solution and Al3Sc (L12 structure) as nanosize precipitates. At room temperature, the yield strength is controlled by the superposition of solid-solution and precipitation strengthening. At 300 °C and at large applied stresses, the creep st...
متن کاملReview of creep cavitation and rupture of low Cr alloy and its weldment
This paper presents a review of creep cavitation and rupture of low Cr alloy and its weldment, particular in the heat-affected zone (HAZ). Creep damage is one of the serious problems for the high temperature industry. One of the computational approaches is continuum damage mechanics which has been developed and applied complementary to the experimental approach and assists in the safe operation...
متن کاملTransformation-Induced Creep and Creep Recovery of Shape Memory Alloy
If the shape memory alloy is subjected to the subloop loading under the stress-controlled condition, creep and creep recovery can appear based on the martensitic transformation. In the design of shape memory alloy elements, these deformation properties are important since the deflection of shape memory alloy elements can change under constant stress. The conditions for the progress of the marte...
متن کاملCorrelation Factor Study of Small Punch Creep Test and Its Life Prediction
A small punch test is one of the innovative methods that can be used to evaluate the properties of a material without destructive harm to the in-service component. Conventionally identifying material properties by a uniaxial test is widely applied to engineering. How the properties obtained from a small punch test can be applied with the same utility has been a goal. In 2006, European Code of P...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallic Materials
سال: 2018
ISSN: 0023-432X
DOI: 10.4149/km_2018_4_205