STATISTICAL STUDY ON ULTIMATE POINT LOAD AND POINT LOAD : SETTLEMENT CHARACTERISTICS OF BORED PRECAST PILES
نویسندگان
چکیده
منابع مشابه
Interpreting Strain Measurements from Load Tests in Bored Piles
In static load tests vibrating wire strain gages are generally used. The advantage of vibrating wire sensors over more conventional electrical resistance or semi-conductor types lies mainly in the sensor output, which is a frequency rather than a voltage or resistance. The frequency output is easier to transmit over long cables and is unaffected by voltage drops such as those which can be broug...
متن کاملUltimate Load Capacity and Behavior of Thin-Walled Curved-Steel Square Struts, Subjected to Compressive Load
There have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. One set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. Different lengths of curved struts are fabricated so as to cover a practical ...
متن کاملEconomic Load Dispatch using PSO Algorithm Based on Adaptive Learning Strategy Considering Valve point Effect
Abstract: In recent years due to problems such as population growth and as a result increase in demand for electrical energy, power systems have been faced with new challenges that not existed in the past. One of the most important issues in modern power systems is economic load dispatch, which is a complex optimization problem with a large number of variables and constraints. Due to the comple...
متن کاملLateral Load Tests on Small-Diameter Piles for Slope Remediation
Slope reinforcement and the use of structural pile elements can be an effective slope remediation alternative when conventional remediation practices (e.g., improved drainage) fail to consider the causal factors leading to slope instability (e.g., strength loss due to weathering). An experimental research program was aimed at developing a rapid, cost-effective, and simple remediation system tha...
متن کاملStrength determination of high-power LED die using point-load and line-load tests
The strength of high-power light emitting diode (LED) dies, cut from wafers with a laser, has to be determined for the need of design and quality control in order to assure the good reliability of packages in manufacturing and service. The objective of this study is to determine the strength of high-power LED die with a size of 1 1 0.1 mm by point-load test (PLT) and line-load test (LLT) associ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 1992
ISSN: 0910-8025,2433-0000
DOI: 10.3130/aijsx.436.0_81