Study and Design Evaluation of RF CMOS Oscillators
نویسندگان
چکیده
منابع مشابه
Simulation and Design of Rf Oscillators
An accurate simulation and design was achieved with Computer-Aided-Engineering (CAE) of RF oscillators. Signal and phase noise modeling of all passiveand active components in the RF oscillator circuit is the prerequisite for accurate simulation. The design showed a very good agreement between simulated and measured data. The required modeling methods, the measurements, the used simulation tec...
متن کاملDesign Issues in CMOS Differential LC Oscillators
An analysis of phase noise in differential crosscoupled inductance–capacitance (LC) oscillators is presented. The effect of tail current and tank power dissipation on the voltage amplitude is shown. Various noise sources in the complementary cross-coupled pair are identified, and their effect on phase noise is analyzed. The predictions are in good agreement with measurements over a large range ...
متن کاملa study on the design of bio-ethanol process from date wastes of sistan and baluchistan province
اتانول کاربردهای متنوعی در صنایع لاستیک سازی، رنگسازی، حلالها ومکمل سوخت خودرو دارد. اتانول برخلاف نفت از جمله مواد تجدیدپذیر محسوب می شود که مشکلات زیست محیطی و آلودگی نیز ایجاد نمی کند. استفاده از اتانول به عنوان مکمل سوختخودروها از جمله مهمترین مصارف صنعتی این ماده بشمار می رود. با توجه به این موضوع تحقیق و توسعه در زمینه تولید اتانول با درجه خلوص بالا در سطح جهان، و نه تنها در کشور های پیشر...
A New Solution to Analysis of CMOS Ring Oscillators
New equations are proposed for frequency and amplitude of a ring oscillator. The method is general enough to be used for all types of delay stages. Using exact largesignal circuit analysis, closed form equations for estimating the frequency and amplitude of a high frequency ring oscillator are derived as an example. The method takes into account the effect of various parasitic capacitors to...
متن کاملDesign and Analysis of High-Frequency Oscillators in 180nm CMOS
Previous implementations of high frequency oscillators have used either Si-Ge or III-V compound due to the low fmax exhibited in standard CMOS processes. This paper presents and analyzes two commonly used techniques for achieving oscillations above fmax. In addition this paper presents a differential push-push oscillator which is capable of providing a differential output at a frequency above f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2016
ISSN: 0974-5645,0974-6846
DOI: 10.17485/ijst/2016/v9i42/99482