Superplasticity in a nickel silicide alloy-microstructural and mechanical correlations
نویسندگان
چکیده
منابع مشابه
Enhanced superplasticity in commercially pure titanium alloy
The superplasticity of commercially pure titanium alloy at high temperature was studied and the dynamic recrystallization phenomenon of the alloy was investigated by using electron back scattered diffraction. A two-step deformation method was used to increase the ductility of the alloy from 188% to 243%. 2004 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
متن کاملEffect of Mechanical Alloying and Sintering on Phase Transformation, Microstructural Evolution, Mechanical Properties and Density of Zr-Cr Alloy
The purpose of present research was production ofZr-based alloy as the nuclear fuel cladding by mechanical alloying (MA) and sintering process. Firstly, Zr and Cr powders were mechanically alloyed to produce the refractory and hard Zr-10 wt% Cr alloy, and then, the powder mixtures were consolidated by press and following sintering at temperature of 800˚C min. The phase evolution, microstructura...
متن کاملSignatures of electronic correlations in iron silicide.
The intermetallic FeSi exhibits an unusual temperature dependence in its electronic and magnetic degrees of freedom, epitomized by the cross-over from a low-temperature nonmagnetic semiconductor to a high-temperature paramagnetic metal with a Curie-Weiss-like susceptibility. Many proposals for this unconventional behavior have been advanced, yet a consensus remains elusive. Using realistic many...
متن کاملOptimizing the Formation of Nickel Silicide
A review of the formation processes for nickel silicide is given to assess the limitations of using the silicide for sub-65 nanometer technologies. Various aspects attributed to the NiSi formation process are described and addressed by using a two-step process sequence for annealing. The focus of this study was to develop a process sequence with three principal steps to achieve low resistivity ...
متن کاملThe phase evolution, mechanical behavior, and microstructural instability of a fully-lamellar Ti–46Al(at.%) alloy
A Ti–46Al(at.%) polysynthetically twinned alloy, which contained a characteristic lamellar spacing of k 1⁄4 1:3 lm, was converted to a polycrystalline fully-lamellar microstructure with k 1⁄4 19:9 nm using an a-phase solution treatment followed by a2 þ c aging. Tensile experiments, performed on microsamples extracted from within single grains of the polycrystalline material, illustrated that ul...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Engineering: A
سال: 1992
ISSN: 0921-5093
DOI: 10.1016/0921-5093(92)90238-v