Tensile Specimen’s Permanent Die Designing and Its Al-Mg Alloy Specimen’s Tensile Test
نویسندگان
چکیده
منابع مشابه
Nanocrystalline Mg-3%Al Alloy: its Synthesis and Investigation of its Tensile Behavior
The tensile properties of Mg-3%Al nanocrystalline alloys were investigated at different test environment. Bulk nanocrystalline samples of these alloy was successfully prepared by mechanical alloying (MA) followed by cold compaction, sintering, and hot extrusion process. The crystal size of the consolidated milled sample was calculated by X-Ray line profile analysis. The deformation mechanism an...
متن کاملCritical Strain Energy Density from Tensile Specimens
Fracture has always been a serious concern in the design and repair of steel structures such as ships. Because of these concerns, much research has been ongoing in the causes of fractures and in ways which they could be predicted and thus prevented. The objective of this study was to flnd, test and evaluate a method for measuring tht:: critical strain energy density with tensile specimens. Plas...
متن کاملTensile and Creep Testing of Sanicro 25 Using Miniature Specimens
Tensile and creep properties of new austenitic steel Sanicro 25 at room temperature and operating temperature 700 °C were investigated by testing on miniature specimens. The results were correlated with testing on conventional specimens. Very good agreement of results was obtained, namely in yield and ultimate strength, as well as short-term creep properties. Although the creep rupture time was...
متن کاملTensile Deformation and Fracture Mechanism of Bulk Bimodal Ultrafine-Grained Al-Mg Alloy
The tensile fractures of ultrafine-grained (UFG) Al-Mg alloy with a bimodal grain size were investigated at the microand macroscale using transmission electron microscopy (TEM), scanning electron microscopy (SEM) equipped with focused ion beam (FIB), and optical microscopy. The nanoscale voids and crack behaviors near the tensile fracture surfaces were revealed in various scale ranges and provi...
متن کاملInfluence of Notch Depth-to-Width Ratios on J-Integral and Critical Failure Load of Single-Edge Notched Tensile Aluminium 8011 Alloy Specimens
In this paper, the influence of notch depth-to-width ratios on J-integral and critical load of Aluminium 8011 alloy specimens with U-notch under Mode I loading are studied. Using experiments, for a set of specimens having different notch depth–to–width ratios, J-integral was found and the same was verified using analytical methods. Further, using the results obtained from the experiments, failu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2016
ISSN: 2261-236X
DOI: 10.1051/matecconf/20166703009