The New Bridge Converter Control Method
نویسندگان
چکیده
منابع مشابه
The New Bridge Converter Control Method
The article describes a new control method of transistor power bridge converter. It is a new one, because of some original solutions and its difference in comparison to existing methods. It’s irrelevant of load, similar to the “phase shifted” control method. It is easy to realize using ordinary electronic elements. A significant advantage of method is the possibility of permanent output current...
متن کاملA New ZVS-PWM Full-Bridge Converter
A full-bridge converter which employs a coupled inductor to achieve zero-voltage switching of the primary switches in the entire line and load range is described. Because the coupled inductor does not appear as a series inductance in the load current path, it does not cause a loss of duty cycle or severe voltage ringing across the output rectifier. The operation and performance of the proposed ...
متن کاملDevelopment of Average Model for Control of a Full Bridge PWM DC-DC Converter
This paper presents a detailed small-signal and transient analysis of a full bridge PWM DC-DC converter designed for high voltage, high power applications using an average model. The derived model is implemented in a typical system and used to produce the small-signal and transient characteristics of the converter. Results obtained in the analysis of the high voltage and high power design examp...
متن کاملThe Novel Control Method for Photovoltaic Converter to the National Grid
In this paper, a novel control method for photovoltaic converter connection to the national gridis presented, so in addition to the injection control by solar arrays to the grid, this method cancompensate reactive power and harmonics in the load current. The system will be connected inparallel between the grid and load. The proposed system supplies all load power consumption(including active po...
متن کاملDesign and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Measurement Science Review
سال: 2010
ISSN: 1335-8871
DOI: 10.2478/v10048-010-0006-6