The Stress Concentration Factor Produced by a Projection under Tensile Load
نویسندگان
چکیده
منابع مشابه
Influence of Stress Concentration Factor on Magnetic Memory Effect of Steel Samples under Dynamic Tension Load
Under the excitation of geomagnetic field, normal component of surface scattering magnetic field intensity Hp(y) changes of steel tensile samples with different stress concentration factors α were studied. Constant amplitude sinusoidal tensile load cycles were applied on 18CrNi4A steel plate samples whose α were respectively 1, 3 and 5. Then the correlation of Hp(y) value changes with loading c...
متن کاملStructure and energy of a DNA dodecamer under tensile load
In the last decade, methods to study single DNA molecules under tensile load have been developed. These experiments measure the force required to stretch and melt the double helix and provide insights into the structural stability of DNA. However, it is not easy to directly relate the shape of the force curve to the structural changes that occur in the double helix under tensile load. Here, sta...
متن کاملExperimental study of grouted sleeve lapping connector under tensile load
The performance of the grouted sleeve lapping connector that is used to connect reinforcement bars in a precast concrete structure is studied. A total of 63 specimens, varying in bar diameter and lap length, were tested under tensile load. The failure modes, ultimate tensile strength values and load-displacement curves of the specimens are discussed in the study. Two equations are proposed for ...
متن کاملMechanical behaviour of articular cartilage under tensile cyclic load.
INTRODUCTION Although fatigue has been implicated in cartilage failure, there are only two published studies in this area, by the same author. However, in these previous studies cartilage was tested in the direction parallel to that of collagen orientation in the superficial layer, where it possesses greater tensile strength. In the present work, articular cartilage was also tested along the di...
متن کاملDetermination The Stress Intensity Factor in The Un-Central Edge Cracks With The concentrated Load
The stress distribution on the tip of the cracks and the stress intensity factor on them are the main courses in the fracture mechanic. The stress intensity factor of the cracks with the different load exited and the different geometry are listed in the tables of the standard books. In all of them, the cracks are located in the central point of the plates. In the uniform edge loaded case, the c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1968
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.11.739