The tensile and tensile-creep deformation behavior of Ti–8Al–1Mo–1V(wt%)
نویسندگان
چکیده
منابع مشابه
Tensile Creep and Creep-Recovery Behavior of a SiC-Fiber─Si3N4-Matrix Composite
The tensile creep and creep-recovery behavior of a unidirectional Sic-fiher/Si,N,-matrix composite was investigated at 1200°C in air. A primary objective of the study was to determine how various sustained and cyclic creep loading histories would influence the creep rate, accumulated creep strain, and the amount of strain recovered upon specimen unloading. The key results obtained from the inve...
متن کاملTensile creep behaviour of polymethylpentenesilica nanocomposites
For the first time, poly(4-methyl-1-pentene) (PMP) nanocomposites were prepared by melt compounding 2 vol% of fumed silica nanoparticles, in order to study the role of the nanofiller surface area and functionalization on the tensile mechanical response of the material, with particular focus on its creep behaviour. The high optical transparency of the polymer matrix was substantially preserved i...
متن کاملTensile Creep of Polycrystalline Near-Stoichiometric NiAl
Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...
متن کاملHot Deformation Behavior of Haynes 25 by the Hot Tensile Test
In the present work, hot tensile behavior of Haynes 25 Co-base alloy was investigated in the temperature range of 950-1200 ˚C and 0.1 s-1. Thermodynamic calculations showed that M23C6 and M6C carbides were stable below 1000 ˚C and above 1050 ˚C, respectively. Stress-strain curves also indicated an unusual trend of strain fracture. It was observed that with increasing temperature from 950 to 105...
متن کاملA nano-tensile tester for creep studies
Free-standing metallic thin films are increasingly used as structural components in MEMS. In commercial devices, long-term reliability is essential, which requires determining time-dependent mechanical properties of these films. The uniaxial tensile test is a preferred method due to uncomplicated determination of the stress and strain state. However, at the MEMS-scale this method is not straigh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Engineering: A
سال: 2015
ISSN: 0921-5093
DOI: 10.1016/j.msea.2015.03.059