Thermal design power and vectorized instructions behavior
نویسندگان
چکیده
منابع مشابه
Assessment of Thermal Behavior and Development of Thermal Design Guidelines for Integrated Power Electronics Modules
With the increase dependency on electricity to provide correct form of electricity for lightning, machines, and home and office appliances, the need for the introduction of high reliability power electronics in converting the raw form of electricity into efficient electricity for these applications is uprising. One of the most common failures in power electronics is temperature related failure ...
متن کاملThermal Design of Power Electronic Devices and Modules
This work describes a way to apply 3D Finite Element (FE) analysis to the thermal design of power electronic modules using simplified geometry models of the system components. The method here presented can overcome the problem of solving equation systems with a very high number of Degrees Of Freedom (DOF) due to complex geometry of a power module.
متن کاملThermal modeling and design of power converters with tight thermal constraints
0026-2714/$ see front matter 2012 Elsevier Ltd. A http://dx.doi.org/10.1016/j.microrel.2012.06.102 ⇑ Corresponding author at: Dipartimento di Ingeg versity of Parma, viale G.P. Usberti, 181/a, 43124 905818; fax: +39 0521 905822. E-mail address: [email protected] (P. Cova). The aim of this paper is to show and discuss results of 3D finite-element simulations for thermal management design with ...
متن کاملIntegrated EMI/Thermal Design for Switching Power Supplies
(ABSTRACT) This work presents the modeling and analysis of EMI and thermal performance for switch power supply by using the CAD tools. The methodology and design guidelines are developed. By using a boost PFC circuit as an example, an equivalent circuit model is built for EMI noise prediction and analysis. The parasitic elements of circuit layout and components are extracted analytically or by ...
متن کاملRF Electro-Thermal Modeling of LDMOSFETs for Power-Amplifier Design
A new approach for the electro-thermal modeling of LDMOSFETs for power-amplifier design that bypasses pulsed-IVs and pulsed-RF measurements is presented in this paper. The existence of low-frequency dispersion in LDMOSFETs is demonstrated by comparing pulsed IVs with iso-thermal IVs. The modeling technique uses iso-thermal IV and microwave measurements to obtain the temperature dependence of sm...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Concurrency and Computation: Practice and Experience
سال: 2021
ISSN: 1532-0626,1532-0634
DOI: 10.1002/cpe.6261