Thermal fracture characteristics of an interface crack subjected to temperature variations
نویسندگان
چکیده
منابع مشابه
Cement-Implant Interface Fracture Failure by Crack Initiation Due to Interface Cavity Stress Concentration
Nowadays total joint replacements are widely used in the world, so in average 800,000 joint surgeries are done yearly only in Europe and North America. However implant loosening is and remains as the major issue of all implant failures and therefore causes revision surgery procedures. Studies and experiments have identified poor fixation of implants most likely is the main cause of long term im...
متن کاملCrack Tip Constraint for Anisotropic Sheet Metal Plate Subjected to Mode-I Fracture
On the ground of manufacturing, sheet metal parts play a key role as they cover about half of the production processes. Sheet metals are commonly obtained from rolling and forming processes which causes misalignment of micro structure resulting obvious anisotropic characteristics and micro cracks. Presence of micro cracks poses serious attention, when stresses at the tip reach to the critical v...
متن کاملMixed Mode Loading of an Interface Crack Subjected to Creep Conditions
Interface cracks are seldom subjected to pure Mode I or pure Mode II conditions. Station~y interface cracks between two distinct, bonded elastic-creep materials subjected to remotely applied mixed mode loading are simulated. The finite element method (FEM) is used to examine crack tip fields and candidate driving force parameters for crack growth. Plane strain conditions are assumed. In most ca...
متن کاملCongenital heart defects in chick embryos subjected to temperature variations.
• Several epidemiological studies" have shown a positive correlation between viral diseases early in pregnancy and congenital heart disease in human beings. Since viral diseases are accompanied commonly by fever, it was considered important to investigate the effect of high temperature alone on the development of the heart in chick embryos. It was also thought that incubation at low temperature...
متن کاملMULTI FRACTURE/DELAMINATION ANALYSIS OF COMPOSITES SUBJECTED TO IMPACT LOADINGS
A combined finite/ discrete element method is presented for modelling of composite specimens subjected to dynamic/impact loadings. The main task is set on developing an algorithm for simulation of potential bonding and debonding/delamination phenomena during impact or general dynamic loading conditions. In addition, full fracture analysis can also be performed. The proposed approach adopts a ge...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Production Engineering Archives
سال: 2020
ISSN: 2353-7779
DOI: 10.30657/pea.2020.26.12