TiB2 Plating Using Continuous and Pulse Current in Molten Salt Electrolyte
نویسندگان
چکیده
منابع مشابه
Electrodeposition of Zinc From Low Temperature Molten Salt Electrolyte: Part I-Imidazole And Zinc-Chloride Electrolyte
Our R & D work was focused on the electro deposition of Zinc from imidazole as low temperature molten salt (LTMS) electrolyte with zinc chloride as a supporting salt at <100o C., without required controls from the previous existing non aqueous baths as well additive free system for the zinc deposition. Surface morphological studies and crystallographic orientation results were evaluated.
متن کاملChronoamperometric Determination of Solid State Diffusion Coefficients in Copper-Gold Alloys Using a Molten Salt Electrolyte
für Naturforschung in cooperation with the Max Planck Society for the Advancement of Science under a Creative Commons Attribution 4.0 International License. Dieses Werk wurde im Jahr 2013 vom Verlag Zeitschrift für Naturforschung in Zusammenarbeit mit der Max-Planck-Gesellschaft zur Förderung der Wissenschaften e.V. digitalisiert und unter folgender Lizenz veröffentlicht: Creative Commons Namen...
متن کاملPreparation of the TiB2 coatings by electroplating in molten salts
The improvement of titanium diboride (TiB2) coatings over the molybdenum substrate was investigated by comparing the electrochemical techniques of continuous current plating (CCP) and periodically interrupted current (PIC). The solvent used was a eutectic Flinak mixture (LiF–NaF– KF, 46.5:11.5:42molar ratio) with solutes K2TiF6 andKBF4 with the electrochemically-active components in themolar ra...
متن کاملMolten-salt Reactor Chemistry
This document summarizes the large program of chemical research and development which led to selection of fuel and coolant compositions for the Molten-Salt Reactor Experiment (MSRE) and for subsequent reactors of this type. Chemical behavior of the LiF-BeFrZrFrUF4 fuel mixture and behavior of fission products during power operation of MSRE are presented. A discussion of the chemical reactions w...
متن کاملSecondary aluminium-iron (III) chloride batteries with a low temperature molten salt electrolyte
Secondary aluminium-iron (III) chloride batteries using a low temperature molten salt electrolyte were constructed and tested. Discharge current densities were in the range 5 to 100mA ( ~ 1 to 2 0 m A c m 2 ; ~ C/4 to 5C); charging currents were 5 m A (C/4 toC/2). Utilization of the positive electrode reactant was low due to the discharge rates and loading procedure. The mode for self discharge...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Proceedings Volumes
سال: 1998
ISSN: 0161-6374,2576-1579
DOI: 10.1149/199811.0146pv