Wall Geometry Effects on Atomization Characteristics of an Impingement-Jet Type Jet Engine Fuel Injector
نویسندگان
چکیده
منابع مشابه
Nozzle Geometry Effects in Liquid Jet Array Impingement
The use of impinging liquid jets in electronics thermal management is attracting some consideration due to their very high heat transfer coefficients, hot spot targeting capabilities and moderate hydraulic power requirements. In this investigation an experimental study of the cooling capabilities of impinging water jet arrays is presented. Of particular interest here is the influence that the i...
متن کاملRarefication Effects on Jet Impingement Loads
Rarefication effects on jet impingement loads are studied by comparing recent new formulas at the collisionless flow limit and numerical simulations. The jet exit size is finite, and can be either planar or round. In the simulations, the jets have different degrees of rarefication, with a Knudsen (Kn) number ranging from 0 to infinity; i.e., the jet flows can be continuum, collisional, or colli...
متن کاملModeling of Turbulence Effects on Liquid Jet Atomization
Recent experimental investigations and physical modeling studies have indicated that turbulence behaviors within a liquid jet have considerable effects on the atomization process. For certain flow regimes, it has been observed that the liquid jet surface is highly turbulent. This turbulence characteristic plays a key role on the breakup of the liquid jet near to the injector exit. Other experim...
متن کاملThermal Performance of Jet Impingement with Spent Flow Management
The present study proposes novel micro-jet impingement heat sink with effusion holes for flow extraction. The design consists of impingement nozzles surrounded by multiple effusion holes to take away the spent fluid. A three-dimensional numerical model is used for steady, incompressible, laminar flow and conjugate heat transfer for the performance analysis of the proposed design. The computatio...
متن کاملAn experimental study of a radial wall jet formed by the normal impingement of a round synthetic jet
The flow field of a radial wall jet created by the impingement of a round synthetic jet normal to a flat surface was characterized using hot-wire anemometry. In the synthetic wall jets the width of the outer layer was observed to increase linearly with the radial distance along the wall, while the local maximum velocity varied inversely. The synthetic wall jet exhibits self-similar behavior as ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 2005
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.71.2568