ZVS PWM Boost Chopper and ZVS Full-Bridge DC-DC Converter Cascaded 2-Stage Power Conversion System
نویسندگان
چکیده
منابع مشابه
A New ZVS-PWM Full-Bridge Converter
A full-bridge converter which employs a coupled inductor to achieve zero-voltage switching of the primary switches in the entire line and load range is described. Because the coupled inductor does not appear as a series inductance in the load current path, it does not cause a loss of duty cycle or severe voltage ringing across the output rectifier. The operation and performance of the proposed ...
متن کاملSimulation of a ZVS Interleaved Boost DC-DC Converter by using Photovoltaic System
This paper a novel yet simple zero-voltage switching (ZVS) interleaved boost power factor correction (PFC )DC/DC converter used to charge the traction battery of an electric vehicle from the utility systems. The proposed topology consists of a passive auxiliary circuit, placed between two phases of the interleaved front-end boost DC-DC converter, provides enough current to charge and discharge ...
متن کاملA Novel Single-stage AC/DC Converter with ZVS Characteristic
A novel single-stage AC/DC converter is proposed in this letter. The converter is designed by integrating a sepic circuit and a flyback circuit, the circuit work in the quasi-resonance state, and the switch is turned on in the zero voltage switching (ZVS) state, which decreased the switching losses of the converter Streszczenie. Opisano nowy konwerter AC/DC. Układ pracuje w stanie quasi-rezonan...
متن کاملA Zvs - Pwm Three - Phase Current - Fed Push – Pull Dc – Dc Converter in Microgrids
In this paper, a ZVS-PWM threephase current-fed push–pull dc–dc converter is proposed. When compared to single-phase topologies, the three-phase dc–dc conversion increases the power density, uses the magnetic core of the transformer more efficiently, reduces the stress on switches, and requires smaller filters since the frequency for its design is higher. The proposed converter employs an activ...
متن کاملMPPT Based Dc-Dc Converter with ZVS & ZCS Technique
In this paper, a DC–DC converter topology with a zero voltage and zero current switching control technique [8] has been proposed for solar PV applications. The proposed converter combine the feature of buck–boost operation capability, at the same time, it can carry out zero voltage and zero current switching on the primary side of the converter transformer. The proposed work has been carried ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Power Electronics
سال: 2004
ISSN: 1348-8538,1884-3239
DOI: 10.5416/jipe2003.30.0_65