P-ZnO/n-Si Photodiodes Prepared by Ultrasonic Spraying Pyrolysis Method
نویسندگان
چکیده
ZnO ultraviolet (UV)/visible photodiodes were fabricated. The N-In codoped p-type ZnO films were deposited on (111)-oriented silicon substrate by ultrasonic spraying pyrolysis method. It was found the photocurrent approximately 3.9 10 A at a bias of 1 V and a photocurrent to dark current contrast ratio higher than around two orders of magnitude. The photodiodes exhibited two higher responsive regions denoted as A and B, respectively. Region A at wavelength from 400 nm to 700 nm was owing to ZnO film absorption occurring through the band-to-deep level, and region B at wavelength from 700 nm to 1000 nm was owing to Si substrate absorption occurring through the band edge.
منابع مشابه
DMMP Sensing Performance of Undoped and Al Doped Nanocrystalline ZnO Thin Films Prepared by Ultrasonic Atomization and Pyrolysis Method
Highly textured undoped (pure) and Al doped ZnO nanocrystalline thin films prepared by ultrasonic atomization and pyrolysis method are reported in this paper. ZnCl2 water solution was converted into fine mist by ultrasonic atomizer (Gapusol 9001 RBI Meylan, France). The mist was pyrolyzed on the glass substrates in horizontal quartz reactor placed in furnace. The Structural and microstructural ...
متن کاملElectrical Properties of CZO Films Prepared by Ultrasonic Spray Pyrolysis
CuZnO (CZO) films have attracted increasing amounts of attention due to their promising potential applications in semiconductor devices. ZnO shows n-type conductivity, and attempts have been made to dope several elements in ZnO to improve the electrical properties. This study investigated the electrical property transitions of CZO films and determined the copper concentration at which the condu...
متن کاملThe Influence of Hydrogen Gas Treatment on the Characteristics of ZnO Films
This study presents a zinc oxide (ZnO) film deposited on a glass substrate by ultrasonic spraying pyrolysis. The ZnO nanostructure was formed by treating the as-deposited ZnO films with hydrogen. The root-mean-square (RMS) roughness increases from 5.83 nm to 12.53 nm during the treatment for 20 min, but slightly decreases to 11.87 nm at a treatment time of 30 min. In the range 400-500 nm, the t...
متن کاملEvolution of the Morphology of Zinc Oxide/Silica Particles Made by Spray Combustion
Pure and mixed ZnO-SiO2 particles were prepared by flame spray pyrolysis (FSP) of zinc acetate (ZA) and either hexamethyldisiloxane (HMDSO) or SiO2-sol dispersed in either methanol or a water-in-oil emulsion. The product particles were characterized by nitrogen adsorption, infrared absorption and X-ray diffraction. The evolution of solid or hollow particle formation along the flame axis was elu...
متن کاملSynthesis of ZnO Nanoparticles by Spray Pyrolysis Method
Zinc oxide (ZnO) nanoparticles were synthesized by spray pyrolysis method using an aqueous solution of zinc acetate at various concentrations from 5 to 25 wt%. The decomposition of precursor solutions was carried out at 800, 1000 and 1200ºC under different atomizing pressures. The crystal structure and morphology of synthesized nanoparticles were characterized by X-Ray Diffraction ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010